Initial commit of the librem5.h configuration Signed-off-by: Angus Ainslie <an...@akkea.ca> --- include/configs/librem5.h | 171 ++++++++++++++++++++++++++++++++++++++ 1 file changed, 171 insertions(+) create mode 100644 include/configs/librem5.h
diff --git a/include/configs/librem5.h b/include/configs/librem5.h new file mode 100644 index 0000000000..e20516ffd6 --- /dev/null +++ b/include/configs/librem5.h @@ -0,0 +1,171 @@ +/* SPDX-License-Identifier: GPL-2.0+ */ +/* + * Copyright 2017 NXP + * Copyright 2018 Emcraft Systems + * Copyright 2019 Purism + * + */ + +#ifndef __LIBREM5_H +#define __LIBREM5_H + +/* #define DEBUG */ + +#include <version.h> +#include <linux/sizes.h> +#include <asm/arch/imx-regs.h> + +#ifdef CONFIG_SECURE_BOOT +#define CONFIG_CSF_SIZE 0x2000 /* 8K region */ +#endif + +#define CONFIG_SPL_MAX_SIZE (148 * 1024) +#define CONFIG_SYS_MONITOR_LEN (512 * 1024) +#define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR +#define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR 0x300 +#define CONFIG_SYS_MMCSD_FS_BOOT_PARTITION 1 + +#ifdef CONFIG_SPL_BUILD +#define CONFIG_SPL_THERM_SUPPORT +#define CONFIG_SPL_WATCHDOG_SUPPORT +#define CONFIG_SPL_DRIVERS_MISC_SUPPORT +#define CONFIG_SPL_LDSCRIPT "arch/arm/cpu/armv8/u-boot-spl.lds" +#define CONFIG_SPL_STACK 0x187FF0 +#define CONFIG_SPL_GPIO_SUPPORT +#define CONFIG_SPL_MMC_SUPPORT +#define CONFIG_SPL_BSS_START_ADDR 0x00180000 +#define CONFIG_SPL_BSS_MAX_SIZE 0x2000 /* 8 KB */ +#define CONFIG_SPL_STACK_R_ADDR 0x42300000 +#define CONFIG_SPL_STACK_R +#define CONFIG_SYS_SPL_MALLOC_START 0x42200000 +#define CONFIG_SYS_SPL_MALLOC_SIZE 0x80000 /* 512 KB */ +#define CONFIG_SYS_ICACHE_OFF +#define CONFIG_SYS_DCACHE_OFF + +#define CONFIG_MALLOC_F_ADDR 0x182000 /* malloc f used before GD_FLG_FULL_MALLOC_INIT */ + +#define CONFIG_SPL_ABORT_ON_RAW_IMAGE /* For RAW image gives a error info not panic */ + +#undef CONFIG_SPL_DM_PMIC +#undef CONFIG_SPL_DM_I2C +#undef CONFIG_SPL_DM_PMIC_BD71837 +#undef CONFIG_DM_USB +#undef CONFIG_SPL_DM_USB +#undef CONFIG_USB_DWC3_GENERIC +#undef CONFIG_DEVRES + +#define CONFIG_SYS_I2C + +#define CONFIG_POWER_BD71837 +#define CONFIG_POWER_BD71837_I2C_BUS 0 +#define CONFIG_POWER_BD71837_I2C_ADDR 0x4B + +#define CONFIG_SPL_DMA_SUPPORT + +#define CONFIG_SYS_FSL_USDHC_NUM 1 + +#else /* CONFIG_SPL_BUILD*/ + +#define CONFIG_SYS_FSL_USDHC_NUM 2 + +#define CONFIG_USB_MAX_CONTROLLER_COUNT 1 + +#define CONFIG_USBD_HS + +#define CONFIG_USB_GADGET_VBUS_DRAW 2 + +#endif /* CONFIG_SPL_BUILD*/ + +#define CONSOLE_ON_UART1 +#define CONFIG_BAUDRATE 115200 + +#ifdef CONSOLE_ON_UART1 +#define CONFIG_MXC_UART_BASE UART1_BASE_ADDR +#define CONSOLE_UART_CLK 0 +#define CONSOLE "ttymxc0" +#elif defined(CONSOLE_ON_UART2) +#define CONFIG_MXC_UART_BASE UART2_BASE_ADDR +#define CONSOLE_UART_CLK 1 +#define CONSOLE "ttymxc1" +#elif defined(CONSOLE_ON_UART3) +#define CONFIG_MXC_UART_BASE UART3_BASE_ADDR +#define CONSOLE_UART_CLK 2 +#define CONSOLE "ttymxc2" +#elif defined(CONSOLE_ON_UART4) +#define CONFIG_MXC_UART_BASE UART4_BASE_ADDR +#define CONSOLE_UART_CLK 3 +#define CONSOLE "ttymxc3" +#else +#define CONFIG_MXC_UART_BASE UART1_BASE_ADDR +#define CONSOLE_UART_CLK 0 +#define CONSOLE "ttymxc0" +#endif + +#define CONFIG_REMAKE_ELF + +#define CONFIG_BOARD_POSTCLK_INIT + +/* Flat Device Tree Definitions */ +#define CONFIG_OF_BOARD_SETUP + +#ifndef CONFIG_SPL_BUILD +#define BOOT_TARGET_DEVICES(func) \ + func(MMC, mmc, 0) \ + func(MMC, mmc, 1) \ + func(USB, usb, 0) \ + func(PXE, pxe, na) \ + func(DHCP, dhcp, na) +#include <config_distro_bootcmd.h> +#else +#define BOOTENV +#endif + +/* Initial environment variables */ +#define CONFIG_EXTRA_ENV_SETTINGS \ + "scriptaddr=0x80000000\0" \ + "pxefile_addr_r=0x80100000\0" \ + "kernel_addr_r=0x80800000\0" \ + "fdt_addr_r=0x83000000\0" \ + "ramdisk_addr_r=0x83800000\0" \ + "console=" CONSOLE ",115200\0" \ + "bootargs=u_boot_version=" PLAIN_VERSION "\0" \ + "stdin=nc,serial\0" \ + "stdout=nc,serial\0" \ + "stderr=nc,serial\0" \ + BOOTENV + +/* Link Definitions */ +#define CONFIG_SYS_TEXT_BASE 0x40200000 + +#define CONFIG_SYS_INIT_RAM_ADDR 0x40000000 +#define CONFIG_SYS_INIT_RAM_SIZE 0x80000 +#define CONFIG_SYS_INIT_SP_OFFSET \ + (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE) +#define CONFIG_SYS_INIT_SP_ADDR \ + (CONFIG_SYS_INIT_RAM_ADDR + CONFIG_SYS_INIT_SP_OFFSET) + +#define CONFIG_ENV_OVERWRITE +#define CONFIG_MMCROOT "/dev/mmcblk0p2" /* USDHC1 */ + +#define CONFIG_SYS_SDRAM_BASE 0x40000000 +#define PHYS_SDRAM 0x40000000 +#define PHYS_SDRAM_SIZE 0xc0000000 /* 3GB LPDDR4 one Rank */ + +#define CONFIG_SYS_ALT_MEMTEST + +/* Monitor Command Prompt */ +#undef CONFIG_SYS_PROMPT +#define CONFIG_SYS_PROMPT "u-boot=> " +#define CONFIG_SYS_PROMPT_HUSH_PS2 "> " +#define CONFIG_SYS_CBSIZE 1024 +#define CONFIG_SYS_MAXARGS 64 +#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE +#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + \ + sizeof(CONFIG_SYS_PROMPT) + 16) +#define CONFIG_SYS_FSL_ESDHC_ADDR 0 + +#ifdef CONFIG_CMD_SF +#define CONFIG_SF_DEFAULT_BUS 0 +#define CONFIG_SF_DEFAULT_CS 0 +#endif +#endif -- 2.25.1
