Dear All
I use BDI3000 debugger to debug my custom board using PPC440EP , using Yosemite
config file as base.
After board power on following messages are shown:
- TARGET: waiting for target Vcc
- TARGET: processing power-up delay
- TARGET: processing user reset request
- TARGET: resetting target passed
- TARGET: processing target startup ....
- TARGET: core #0 PVR is 0x422218D4
- TARGET: processing target startup passed
440EP>go
440EP>
According to BDI3000 manual it's expected to see this message after go command:
- TARGET: core #0 has entered debug mode
But i don't have it.
After go command i see u-boot messages in serial communication page but I think
there is an error during startup in debugger and because of that i don't have
this message.
Is there any idea about this error?
Thank you all!
Tim Rachman
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
