We use CONFIG_SYS_RAMBOOT for when boot out of NAND, SPI, SDHC/MMC
and utilize a L2 or L3 cache in SRAM mode.  In this case we will
end up changing the cache from SRAM mode back to cache before we
relocate the environment properly in env_relocate().

So we need to manual relocate the env pointer out of SRAM into DDR.

Signed-off-by: Kumar Gala <ga...@kernel.crashing.org>
---
 arch/powerpc/lib/board.c |   12 ++++++++++++
 1 files changed, 12 insertions(+), 0 deletions(-)

diff --git a/arch/powerpc/lib/board.c b/arch/powerpc/lib/board.c
index 2e0749d..5ce9caa 100644
--- a/arch/powerpc/lib/board.c
+++ b/arch/powerpc/lib/board.c
@@ -645,6 +645,18 @@ void board_init_r (gd_t *id, ulong dest_addr)
        gd->cpu += dest_addr - CONFIG_SYS_MONITOR_BASE;
 #endif
 
+#if defined(CONFIG_MPC85xx) && defined(CONFIG_SYS_RAMBOOT)
+       /*
+        * We use CONFIG_SYS_RAMBOOT for when boot out of NAND, SPI, SDHC/MMC
+        * and utilize a L2 or L3 cache in SRAM mode.  In this case we will
+        * end up changing the cache from SRAM mode back to cache before we
+        * relocate the environment properly in env_relocate().
+        *
+        * So we need to manual relocate the env pointer out of SRAM into DDR.
+        */
+       gd->env_addr += dest_addr - CONFIG_SYS_MONITOR_BASE;
+#endif
+
 #ifdef CONFIG_SERIAL_MULTI
        serial_initialize();
 #endif
-- 
1.7.2.3

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to