On 04.11.21 04:55, Samuel Holland wrote:
None of the sysreset drivers do anything beyond providing sysreset
uclass ops. They should depend on the sysreset uclass.
Reviewed-by: Heinrich Schuchardt <heinrich.schucha...@canonical.com>
Signed-off-by: Samuel Holland <sam...@sholland.org>
Reviewed-by: Stefan Roese <s...@denx.de>
Thanks,
Stefan
---
(no changes since v2)
Changes in v2:
- Extend the "if SYSRESET" block to the end of the file.
drivers/sysreset/Kconfig | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/sysreset/Kconfig b/drivers/sysreset/Kconfig
index 43a948cfcd..de75c9cccc 100644
--- a/drivers/sysreset/Kconfig
+++ b/drivers/sysreset/Kconfig
@@ -118,8 +118,6 @@ config SYSRESET_TI_SCI
This enables the system reset driver support over TI System Control
Interface available on some new TI's SoCs.
-endif
-
config SYSRESET_SYSCON
bool "Enable support for mfd syscon reboot driver"
select REGMAP
@@ -162,4 +160,6 @@ config SYSRESET_MPC83XX
help
Reboot support for NXP MPC83xx SoCs.
+endif
+
endmenu
Viele Grüße,
Stefan
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-51 Fax: (+49)-8142-66989-80 Email: s...@denx.de
