Hi, I have a problem with my linksys wrt1900acs. My main question is this a hardware problem or software problem? Is it possible to address? I have started researching and have tried with "kwboot" under Windows VM - Ubuntu 20 - Linux but I have a problem with usb serial connection. I have tried several things but I understand that it isn't possible to start USB to Serial on a Windows VM. I will expect your response. Thank you in advance.
All the best Dilyan I see the following Log from U-Boot with PuTTy under Windows 10: BootROM - 1.73 Booting from NAND flash General initialization - Version: 1.0.0 Detected Device ID 6820 High speed PHY - Version: 2.0 Init RD NAS topology Serdes Lane 3 is USB3 Serdes Lane 4 is SGMII board SerDes lanes topology details: | Lane # | Speed | Type | -------------------------------- | 0 | 06 | SATA0 | | 1 | 05 | PCIe0 | | 2 | 06 | SATA1 | | 3 | 05 | USB3 HOST1 | | 4 | 05 | PCIe1 | | 5 | 00 | SGMII2 | -------------------------------- :** Link is Gen1, check the EP capability PCIe, Idx 0: Link upgraded to Gen2 based on client cpabilities :** Link is Gen1, check the EP capability PCIe, Idx 1: remains Gen1 High speed PHY - Ended Successfully DDR3 Training Sequence - Ver TIP-1.26.0 mvSysEnvGetTopologyUpdateInfo: TWSI Read failed WL Supp: IF 0 busId 1 Failed ! WL Supp: IF 0 failed ddr3TipDynamicWriteLevelingSupp failure ******** DRAM initialization Failed (res 0x1) ******** DDR3 run algorithm - FAILED 0x1 DDR3 Training Sequence - FAILED ********** DRAM initialization failed! ******** -- Dilyan
