The GW71xx has a USB Type-C connector with USB 2.0 signaling. GPIO1_12
is the power-enable to the TPS25821 Source controller and power switch
responsible for monitoring the CC pins and enabling VBUS. Therefore
GPIO1_12 must always be enabled and the vbus output enable from the
IMX8MM can be ignored.
To fix USB OTG VBUS enable a pull-up on GPIO1_12 to always power the
TPS25821 and change the regulator output to GPIO1_10 which is
unconnected.
Signed-off-by: Tim Harvey <thar...@gateworks.com>
---
arch/arm/dts/imx8mm-venice-gw71xx.dtsi | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)
diff --git a/arch/arm/dts/imx8mm-venice-gw71xx.dtsi
b/arch/arm/dts/imx8mm-venice-gw71xx.dtsi
index 905b68a3da..8e4a0ce997 100644
--- a/arch/arm/dts/imx8mm-venice-gw71xx.dtsi
+++ b/arch/arm/dts/imx8mm-venice-gw71xx.dtsi
@@ -46,7 +46,7 @@
pinctrl-0 = <&pinctrl_reg_usb1_en>;
compatible = "regulator-fixed";
regulator-name = "usb_otg1_vbus";
- gpio = <&gpio1 12 GPIO_ACTIVE_HIGH>;
+ gpio = <&gpio1 10 GPIO_ACTIVE_HIGH>;
enable-active-high;
regulator-min-microvolt = <5000000>;
regulator-max-microvolt = <5000000>;
@@ -156,7 +156,8 @@
pinctrl_reg_usb1_en: regusb1grp {
fsl,pins = <
- MX8MM_IOMUXC_GPIO1_IO12_GPIO1_IO12 0x41
+ MX8MM_IOMUXC_GPIO1_IO10_GPIO1_IO10 0x41
+ MX8MM_IOMUXC_GPIO1_IO12_GPIO1_IO12 0x141
MX8MM_IOMUXC_GPIO1_IO13_USB1_OTG_OC 0x41
>;
};
--
2.17.1
