> From: Peng Fan <peng....@nxp.com> > Add i.MX8ULP EVK basic support, support SD/I2C/ENET/LPUART > Log as below: I would keep some debug info for now, and after we move > to be stable and production launch, we could drop that. > U-Boot SPL 2021.07-rc4-00164-gb800e19a6b (Jun 29 2021 - 10:23:30 +0800) > Normal Boot > upower_init: soc_id=48 > upower_init: version:11.11.6 > upower_init: start uPower RAM service > user_upwr_rdy_callb: soc=b > user_upwr_rdy_callb: RAM version:12.6 > Turn on switches ok > Turn on memories ok > Clear DDR retention ok > Poll for freq_chg_req on SIM register and change to F1 frequency. > Poll for freq_chg_req on SIM register and change to F0 frequency. > Poll for freq_chg_req on SIM register and change to F1 frequency. > Poll for freq_chg_req on SIM register and change to F2 frequency. > Poll for freq_chg_req on SIM register and change to F1 frequency. > Poll for freq_chg_req on SIM register and change to F2 frequency. > complete > De-Skew PLL is locked and ready > WDT: Not found! > Trying to boot from BOOTROM > image offset 0x8000, pagesize 0x200, ivt offset 0x0 > Load image from 0x3a800 by ROM_API > NOTICE: BL31: v2.4(release):imx_5.10.35_2.0.0_imx8ulp_er-10-gf37e59b94-dirty > NOTICE: BL31: Built : 01:56:58, Jun 29 2021 > NOTICE: upower_init: start uPower RAM service > NOTICE: user_upwr_rdy_callb: soc=b > NOTICE: user_upwr_rdy_callb: RAM version:12.6 > U-Boot 2021.07-rc4-00164-gb800e19a6b (Jun 29 2021 - 10:23:30 +0800) > CPU: Freescale i.MX8ULP rev1.0 at 744 MHz > Reset cause: POR > Boot mode: Single boot > Model: FSL i.MX8ULP EVK > DRAM: 2 GiB > MMC: FSL_SDHC: 0, FSL_SDHC: 2 > Loading Environment from MMC... *** Warning - bad CRC, using default > environment > In: serial@293a0000 > Out: serial@293a0000 > Err: serial@293a0000 > Net: > Warning: ethernet@29950000 (eth0) using random MAC address - 96:35:88:62:e0:44 > eth0: ethernet@29950000 > Hit any key to stop autoboot: 0 > Signed-off-by: Peng Fan <peng....@nxp.com> Applied to u-boot-imx, master, thanks !
Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de =====================================================================
