On 7/2/21 8:03 PM, Da Xue wrote:
SF: Detected gd25lq128 with page size 256 Bytes, erase size 64 KiB, total
16 MiB
SPI mode: 3
meson_spifc spi@8c80: Cannot set mode (err=-19)
Failed to initialize SPI flash at 0:0 (error -19)
I added spi-rx-bus-width = <1> and spi-tx-bus-width = <1>
On Fri, Jul 2, 2021 at 1:44 PM Marek Vasut <ma...@denx.de> wrote:
On 7/2/21 7:24 PM, Da Xue wrote:
Hi Marek,
This patch breaks meson_spifc:
SF: Detected gd25lq128 with page size 256 Bytes, erase size 64 KiB, total
16 MiB
meson_spifc spi@8c80: Cannot set mode (err=-19)
Failed to initialize SPI flash at 0:0 (error -19)
Best,
Da
On Wed, Jun 30, 2021 at 12:49 PM Tom Rini <tr...@konsulko.com> wrote:
On Thu, Jun 10, 2021 at 02:00:00PM +0200, Marek Vasut wrote:
The spi_get_bus_and_cs() may be called on the same bus and chipselect
with different frequency or mode. This is valid usecase, but the code
fails to notify the controller of such a configuration change. Call
spi_set_speed_mode() in case bus frequency or bus mode changed to let
the controller update the configuration.
The problem can easily be triggered using the sspi command:
=> sspi 0:0@1000
=> sspi 0:0@2000
Without this patch, both transfers happen at 1000 Hz. With this patch,
the later transfer happens correctly at 2000 Hz.
Signed-off-by: Marek Vasut <ma...@denx.de>
Cc: Jagan Teki <ja...@amarulasolutions.com>
Cc: Patrick Delaunay <patrick.delau...@foss.st.com>
Applied to u-boot/master, thanks!
--
Tom
Seems like you're hitting this code in drivers/spi/meson_spifc.c
250 static int meson_spifc_set_mode(struct udevice *dev, uint mode)
251 {
252 struct meson_spifc_priv *spifc = dev_get_priv(dev);
253
254 if (mode & (SPI_CPHA | SPI_RX_QUAD | SPI_RX_DUAL |
255 SPI_TX_QUAD | SPI_TX_DUAL))
256 return -ENODEV;
(the -ENODEV code doesn't look right, it should be some -EOPNOTSUP or so)
Can you check which of the mode bits is set and triggers the condition ?
I think you might be missing something like
spi-rx-bus-width = <1>;
spi-tx-bus-width = <1>;
in your DT, but that's a guess.
Can you check which of the mode bits is set and triggers the condition ?
Also, where in the DT did you add spi-rx-bus-width = <1> and
spi-tx-bus-width = <1> ?
Finally, please do not top-post and keep the list on CC.
