Add Yifeng from rockchip.
Hi Chris,
First of all, I think you should remain the origin author info in
the signed-off.
Hi Yifeng,
Please help to review this driver.
Thanks,
- Kever
On 2021/5/26 上午5:49, Chris Morgan wrote:
From: Chris Morgan <macromor...@hotmail.com>
Requesting comments for a proposed patchset for adding the Rockchip
serial flash controller to u-boot. The goal of these patches is to
enable it for the Odroid Go Advance so that it may eventually boot
exclusively from the SFC on mainline U-boot (I have tested this and
it works).
The specific help I need with this patch is:
1) I don't know the best way to upstream the XTX25F128B flash chip.
This chip uses a continuation code for the manufacturer ID, however I
cannot seem to find any way to actually read the continuation code.
There is a risk of this driver, used as-is, to collide with another
chip which has the same manufacturer ID with a different continuation
code.
2) The Rockchip SFC driver itself (as it is mostly as-is from the BSP
U-Boot sources) supports SPI NAND and chips of varying sizes, but my
implementation only permits me to test with a single 128Mb flash chip.
The driver itself does some checking on the bitlen in the routine
rockchip_sfc_xfer() which is what is called for the dm_spi_ops.xfer.
I'm not sure if there is a better way to do this. Additionally, I have
to bit-shift the address written to the SFC as I suspect the value is
meant to be left justified, but I never tested it further.
Additionally, it might be worth mentioning but I noticed the Rockchip
BROM will only boot the TPL/SPL off of the SFC if I write it to address
0x10000. This is not documented and different than the address looked
at for SD card booting (512 * 64 = 0x8000 for SD Card booting). Also,
like the SD card driver I can confirm that if DMA is enabled at the SPL
stage A-TF seems to fail silently, then when Linux loads it hangs.
There is an ifdef to force FIFO mode only in the SPL stage.
Tested: Read (works)
Write (works if you write to an erased sector)
Erase (works)
SPL Read (works if you edit the u-boot,spl-boot-order)
Chris Morgan (5):
spi: rockchip_sfc: add support for Rockchip SFC
rockchip: px30: Add support for using SFC
rockchip: px30: add the serial flash controller
mtd: spi-nor-ids: Add XTX XT25F128B
rockchip: px30: add support for SFC for Odroid Go Advance
arch/arm/dts/px30.dtsi | 38 ++
arch/arm/dts/rk3326-odroid-go2-u-boot.dtsi | 10 +-
arch/arm/dts/rk3326-odroid-go2.dts | 22 +
arch/arm/mach-rockchip/px30/px30.c | 64 ++
drivers/mtd/spi/Kconfig | 6 +
drivers/mtd/spi/spi-nor-ids.c | 8 +
drivers/spi/Kconfig | 8 +
drivers/spi/Makefile | 1 +
drivers/spi/rockchip_sfc.c | 652 +++++++++++++++++++++
9 files changed, 926 insertions(+), 1 deletion(-)
create mode 100644 drivers/spi/rockchip_sfc.c
