Hi Tianrui, On Thu, May 13, 2021 at 1:07 PM Tianrui Wei <tianrui-...@outlook.com> wrote: > > Hi Sean, > > On 5/13/2021 1:14 AM, Sean Anderson wrote: > > > > [snip] > > > >> On 5/8/2021 11:14 PM, Sean Anderson wrote: > >>> On 5/8/21 12:57 AM, Tianrui Wei wrote: > >>>> On 5/7/2021 9:03 PM, Sean Anderson wrote: > >>>>> On 5/6/21 11:48 PM, Tianrui Wei wrote: > >>>>>> On 5/7/2021 11:41 AM, Sean Anderson wrote: > >>>>>>> On 5/6/21 11:28 PM, Tianrui Wei wrote: > >>>>>>>> On 5/7/2021 11:15 AM, Sean Anderson wrote: > >>>>>>>>> On 5/6/21 11:06 PM, Tianrui Wei wrote: > >>>>>>>>>> On 5/7/2021 10:32 AM, Sean Anderson wrote: > >>>>>>>>>>> Please use a log without debug uart. > >>>>>>>>>>> > >>>>>>>>>> So this is the part where it was a little confusing. Disabling > >>>>>>>>>> debug uart acutally doesn't work for some reason, so we had to > >>>>>>>>>> keep it open. Will submit another patch if we got it working > >>>>>>>>>> with debug uart turned off. > >>>>>>>>> > >>>>>>>>> This is a bit of a strange request, but can you try adding > >>>>>>>>> some nops() > >>>>>>>>> (around 10-30) to some function (e.g. board_init). I've been > >>>>>>>>> having > >>>>>>>>> alignment problems in k210, so it could be something similar. > >>>>>>>>> > >> I was wondering if you have any idea what may cause the alignment > >> problems, we're also hitting it constantly and adding nops seems to > >> have no impact so far. > > > > I have no idea :) > > > > If adding nop()s doesn't solve it, it may not be an alignment problem. > > You can also try switching from -Os to -O2, which should move things > > around a bit. > > > > My attempts to dig into this have been stymied by the poor debugging > > tools for the k210. The upstream openocd port only supports debugging > > hart 0. While Canaan's fork supports debugging both harts, you must pick > > the one to debug when launching the debugger. And both debuggers are > > very buggy themselves. > > > > The other problem on the k210 at least is that the typical failure mode > > (trying to read from unaddressable/unmapped addresses) hangs the bus. > > This also has the tendancy of hanging the jtag debug port. > > > I did try to switch from -Os to -O2, and it didn't help either. I've > also encountered > > the same debugger situation unfortunately, so I have not much luck > finding the > > faulty instruction either. Maybe we should bring this issue up with the > others along > > the compilation error?
Sorry I lost the track. What problems are you seeing? Regards, Bin