Dear Adarsh,
In message <cajgxa7etn4l5jbg2ybdexpfc1_69vialtw2yqyhj9vsu7xz...@mail.gmail.com>
you wrote:
>
> I was trying to verify and use 'chpart' command on Beaglebone black with an
> SDHC card ( with multiple partitions ) and am unable to get its exact
> syntax.Is this command applicable to
> any particular category of storage devices (viz. NOR flash,NAND flash etc)??
I agree that it is not obvious from the help output, but the fact
that the chpart command is implemented in the cmd/mtdparts.c source
file gives a clear hint: it works only for MTD devices, not for
general storage devides using DOS (or GPT) partitions.
> => mmc dev 0
> switch to partitions #0, OK
> mmc0 is current device
This is what you should look for. THe help output shoud tell you:
...
mmc dev [dev] [part] - show or set current mmc device [partition]
...
So instead of
> => chpart mmc0:2
> Device nand0 not found!
you would use:
=> mmc dev 0 2
Hope this helps.
Wolfgang Denk
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
A person without a sense of humor is like a wagon without springs --
jolted by every pebble in the road. - Henry Ward Beecher (1813-1887)
