I rebased my dockstar patches on master, after the recent ARM
relocation support for kirkwood had been merged.
I no longer see any of the early console messages that should result
from display_banner, print_cpuinfo, etc. The first thing I see is the
NAND information:
Marvell>> reset
resetting ...
NAND: 256 MiB
In: serial
Out: serial
Err: serial
Net: egiga0
[...]
(I see the same behavior on a cold start, not just a reset.) Can
someone with another kirkwood board please check whether they see this
behavior also, or did I somehow break something when I rebased?
Thanks.
--
Eric Cooper e c c @ c m u . e d u
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
