Hi Dario,

On 23/01/21 07:27PM, Dario Binacchi wrote:
> The patch changes the variable 'n' type from phys_addr_t to int.

This information can very easily be obtained by reading the diff. The 
commit message should also explain _why_ the change is made. For example 
here it would be a good idea to add something like:

  n is used as a loop counter, not as a physical address, and is used in 
  a comparison with an int. So it makes sense to set its type to int.
 
Other than that,

Reviewed-by: Pratyush Yadav <p.ya...@ti.com>
 
> Signed-off-by: Dario Binacchi <dario...@libero.it>
> ---
> 
>  drivers/pinctrl/pinctrl-single.c | 8 ++++----
>  1 file changed, 4 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/pinctrl/pinctrl-single.c 
> b/drivers/pinctrl/pinctrl-single.c
> index c9a6c272bf..49ed15211d 100644
> --- a/drivers/pinctrl/pinctrl-single.c
> +++ b/drivers/pinctrl/pinctrl-single.c
> @@ -75,8 +75,8 @@ static int single_configure_pins(struct udevice *dev,
>                                int size)
>  {
>       struct single_pdata *pdata = dev_get_plat(dev);
> -     int count = size / sizeof(struct single_fdt_pin_cfg);
> -     phys_addr_t n, reg;
> +     int n, count = size / sizeof(struct single_fdt_pin_cfg);
> +     phys_addr_t reg;
>       u32 val;
>  
>       for (n = 0; n < count; n++, pins++) {
> @@ -109,8 +109,8 @@ static int single_configure_bits(struct udevice *dev,
>                                int size)
>  {
>       struct single_pdata *pdata = dev_get_plat(dev);
> -     int count = size / sizeof(struct single_fdt_bits_cfg);
> -     phys_addr_t n, reg;
> +     int n, count = size / sizeof(struct single_fdt_bits_cfg);
> +     phys_addr_t reg;
>       u32 val, mask;
>  
>       for (n = 0; n < count; n++, pins++) {
> -- 
> 2.17.1
> 

-- 
Regards,
Pratyush Yadav
Texas Instruments India

Reply via email to