> There is a QSPI chip connected to the FSPI. Enable the defconfig > to support it. > Signed-off-by: Adam Ford <aford...@gmail.com> > Reviewed-by: Peng Fan <peng....@nxp.com> > diff --git a/configs/imx8mm_beacon_defconfig b/configs/imx8mm_beacon_defconfig > index 49d5453078..2970e5dc71 100644 > --- a/configs/imx8mm_beacon_defconfig > +++ b/configs/imx8mm_beacon_defconfig > @@ -41,6 +41,7 @@ CONFIG_CMD_GPIO=y > CONFIG_CMD_I2C=y > CONFIG_CMD_MMC=y > CONFIG_CMD_PART=y > +CONFIG_CMD_SPI=y > CONFIG_CMD_DHCP=y > CONFIG_CMD_MII=y > CONFIG_CMD_PING=y > @@ -78,6 +79,14 @@ CONFIG_MMC_HS400_ES_SUPPORT=y > CONFIG_MMC_HS400_SUPPORT=y > CONFIG_SPL_MMC_HS400_SUPPORT=y > CONFIG_FSL_USDHC=y > +CONFIG_MTD=y > +CONFIG_DM_MTD=y > +CONFIG_DM_SPI_FLASH=y > +CONFIG_SF_DEFAULT_MODE=0x0 > +CONFIG_SF_DEFAULT_SPEED=10000000 > +CONFIG_SPI_FLASH_BAR=y > +CONFIG_SPI_FLASH_STMICRO=y > +CONFIG_SPI_FLASH_MTD=y > CONFIG_PHYLIB=y > CONFIG_PHY_ATHEROS=y > CONFIG_DM_ETH=y > @@ -102,7 +111,6 @@ CONFIG_DM_SERIAL=y > CONFIG_MXC_UART=y > CONFIG_SPI=y > CONFIG_DM_SPI=y > -CONFIG_SPI_MEM=y > CONFIG_NXP_FSPI=y > CONFIG_SYSRESET=y > CONFIG_SPL_SYSRESET=y Applied to u-boot-imx, master, thanks !
Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de =====================================================================
