This sort of code does not make much sense:
if (ondie_ecc_enabled) {
if (ondie_ecc_enabled) {
Remove the inner if.
The problem was indicated by cppcheck.
Signed-off-by: Heinrich Schuchardt <xypron.g...@gmx.de>
---
drivers/mtd/nand/raw/zynq_nand.c | 10 ++++------
1 file changed, 4 insertions(+), 6 deletions(-)
diff --git a/drivers/mtd/nand/raw/zynq_nand.c b/drivers/mtd/nand/raw/zynq_nand.c
index 92db2aa19c..65817ea7f2 100644
--- a/drivers/mtd/nand/raw/zynq_nand.c
+++ b/drivers/mtd/nand/raw/zynq_nand.c
@@ -1206,12 +1206,10 @@ static int zynq_nand_probe(struct udevice *dev)
nand_chip->options |= NAND_SUBPAGE_READ;
/* On-Die ECC spare bytes offset 8 is used for ECC codes */
- if (ondie_ecc_enabled) {
- nand_chip->ecc.layout = &ondie_nand_oob_64;
- /* Use the BBT pattern descriptors */
- nand_chip->bbt_td = &bbt_main_descr;
- nand_chip->bbt_md = &bbt_mirror_descr;
- }
+ nand_chip->ecc.layout = &ondie_nand_oob_64;
+ /* Use the BBT pattern descriptors */
+ nand_chip->bbt_td = &bbt_main_descr;
+ nand_chip->bbt_md = &bbt_mirror_descr;
} else {
/* Hardware ECC generates 3 bytes ECC code for each 512 bytes */
nand_chip->ecc.mode = NAND_ECC_HW;
--
2.29.2
