Am 2020-11-18 15:06, schrieb Michal Simek:
On 16. 11. 20 22:47, Michael Walle wrote:
Add support to load the bl31 part of the ARM Trusted Firmware by the
SPL.
Signed-off-by: Michael Walle <mich...@walle.cc>
---
.../dts/fsl-ls1028a-kontron-sl28-u-boot.dtsi | 41 +++++++++++++-
board/kontron/sl28/Kconfig | 10 ++++
board/kontron/sl28/Makefile | 6 ++-
board/kontron/sl28/spl_atf.c | 54
+++++++++++++++++++
4 files changed, 109 insertions(+), 2 deletions(-)
create mode 100644 board/kontron/sl28/spl_atf.c
diff --git a/arch/arm/dts/fsl-ls1028a-kontron-sl28-u-boot.dtsi
b/arch/arm/dts/fsl-ls1028a-kontron-sl28-u-boot.dtsi
index 2375549c6e..4b97e9d388 100644
--- a/arch/arm/dts/fsl-ls1028a-kontron-sl28-u-boot.dtsi
+++ b/arch/arm/dts/fsl-ls1028a-kontron-sl28-u-boot.dtsi
@@ -16,7 +16,7 @@
ethernet3 = &enetc6;
};
- binman {
+ binman: binman {
filename = "u-boot.rom";
pad-byte = <0xff>;
@@ -102,6 +102,45 @@
};
};
+#ifdef CONFIG_SL28_SPL_LOADS_ATF_BL31
+&binman {
+ fit {
+ images {
+ bl31 {
+ description = "ARM Trusted Firmware (bl31)";
+ type = "firmware";
+ arch = "arm";
+ os = "arm-trusted-firmware";
+ compression = "none";
+ load = <CONFIG_SL28_BL31_ENTRY_ADDR>;
+ entry = <CONFIG_SL28_BL31_ENTRY_ADDR>;
+
+ blob-ext {
+ filename = "bl31.bin";
+ };
+ };
+ };
+
+ configurations {
+ conf-1 {
+ firmware = "bl31";
+ loadables = "uboot", "bl31";
+ };
+
+ conf-2 {
+ firmware = "bl31";
+ loadables = "uboot", "bl31";
+ };
+
+ conf-3 {
+ firmware = "bl31";
+ loadables = "uboot", "bl31";
+ };
Why do you need 3 the same configurations here?
Because they differ in the fdt, but I still need to change the loadable
property if BL31/BL32 is enabled. See:
https://elixir.bootlin.com/u-boot/v2021.01-rc2/source/arch/arm/dts/fsl-ls1028a-kontron-sl28-u-boot.dtsi#L77
-michael
