This moves "struct nand_bbt_descr largepage_memorybased" into
"onenand_default_bbt" as that's the only place where this is used.
This also removes an entry from .data section. (For me, this section disappears
after relocation).
Signed-off-by: Marek Vasut <marek.va...@gmail.com>
---
drivers/mtd/onenand/onenand_bbt.c | 25 ++++++++++++-------------
1 files changed, 12 insertions(+), 13 deletions(-)
diff --git a/drivers/mtd/onenand/onenand_bbt.c
b/drivers/mtd/onenand/onenand_bbt.c
index 1354877..c5d3905 100644
--- a/drivers/mtd/onenand/onenand_bbt.c
+++ b/drivers/mtd/onenand/onenand_bbt.c
@@ -227,19 +227,6 @@ int onenand_scan_bbt(struct mtd_info *mtd, struct
nand_bbt_descr *bd)
return ret;
}
-/*
- * Define some generic bad / good block scan pattern which are used
- * while scanning a device for factory marked good / bad blocks.
- */
-static uint8_t scan_ff_pattern[] = { 0xff, 0xff };
-
-static struct nand_bbt_descr largepage_memorybased = {
- .options = 0,
- .offs = 0,
- .len = 2,
- .pattern = scan_ff_pattern,
-};
-
/**
* onenand_default_bbt - [OneNAND Interface] Select a default bad block table
for the device
* @param mtd MTD device structure
@@ -252,6 +239,18 @@ int onenand_default_bbt(struct mtd_info *mtd)
struct onenand_chip *this = mtd->priv;
struct bbm_info *bbm;
+ /*
+ * Define some generic bad / good block scan pattern which are used
+ * while scanning a device for factory marked good / bad blocks.
+ */
+ uint8_t scan_ff_pattern[] = { 0xff, 0xff };
+ struct nand_bbt_descr largepage_memorybased = {
+ .options = 0,
+ .offs = 0,
+ .len = 2,
+ .pattern = scan_ff_pattern,
+ };
+
this->bbm = malloc(sizeof(struct bbm_info));
if (!this->bbm)
return -ENOMEM;
--
1.7.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
