Remove some unused functionality to make U-Boot build again.
Especially PCI is not used on the board.

Signed-off-by: Matthias Fuchs <[email protected]>
---
 include/configs/DU405.h |   31 +++++--------------------------
 1 files changed, 5 insertions(+), 26 deletions(-)

diff --git a/include/configs/DU405.h b/include/configs/DU405.h
index 8f1fc78..ff56ac3 100644
--- a/include/configs/DU405.h
+++ b/include/configs/DU405.h
@@ -73,6 +73,11 @@
 #include <config_cmd_default.h>
 
 #undef CONFIG_CMD_NFS
+#undef CONFIG_CMD_EDITENV
+#undef CONFIG_CMD_IMLS
+#undef CONFIG_CMD_CONSOLE
+#undef CONFIG_CMD_LOADB
+#undef CONFIG_CMD_LOADS
 #define CONFIG_CMD_IDE
 #define CONFIG_CMD_ELF
 #define CONFIG_CMD_MII
@@ -126,32 +131,6 @@
 #define CONFIG_SYS_RX_ETH_BUFFER       16      /* use 16 rx buffer on 405 emac 
*/
 
 /*-----------------------------------------------------------------------
- * PCI stuff
- *-----------------------------------------------------------------------
- */
-#define PCI_HOST_ADAPTER 0             /* configure ar pci adapter     */
-#define PCI_HOST_FORCE 1               /* configure as pci host        */
-#define PCI_HOST_AUTO  2               /* detected via arbiter enable  */
-
-#define CONFIG_PCI                     /* include pci support          */
-#define CONFIG_PCI_HOST PCI_HOST_AUTO  /* select pci host function     */
-#define CONFIG_PCI_PNP                 /* do pci plug-and-play         */
-                                       /* resource configuration       */
-
-#define CONFIG_PCI_SCAN_SHOW           /* print pci devices @ startup  */
-
-#define CONFIG_PCI_BOOTDELAY   0       /* enable pci bootdelay variable*/
-
-#define CONFIG_SYS_PCI_SUBSYS_VENDORID 0x12FE  /* PCI Vendor ID: esd gmbh      
*/
-#define CONFIG_SYS_PCI_SUBSYS_DEVICEID 0x0404  /* PCI Device ID: CPCI-ISER4    
*/
-#define CONFIG_SYS_PCI_PTM1LA  0x00000000      /* point to sdram               
*/
-#define CONFIG_SYS_PCI_PTM1MS  0xff000001      /* 16MB, enable hard-wired to 1 
*/
-#define CONFIG_SYS_PCI_PTM1PCI 0x00000000      /* Host: use this pci address   
*/
-#define CONFIG_SYS_PCI_PTM2LA  0xffe00000      /* point to flash               
*/
-#define CONFIG_SYS_PCI_PTM2MS  0xffe00001      /* 2MB, enable                  
*/
-#define CONFIG_SYS_PCI_PTM2PCI 0x04000000      /* Host: use this pci address   
*/
-
-/*-----------------------------------------------------------------------
  * IDE/ATA stuff
  *-----------------------------------------------------------------------
  */
-- 
1.6.1

_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to