[PATCH] serial: sh: Improve FIFO empty check on RX

[Marek Vasut]

If the SCIF is receiving data quickly enough, it may happen that the
SCxSR_RDxF flag is cleared in sh_serial_getc_generic(), while the
FIFO still contains data. If that happens, the serial_getc_check()
reports no data in the FIFO as the flag is no longer set. Add one
more check, if the SCxSR_RDxF is not set, read out the FIFO level
and if there are still characters in the FIFO, permit reading them
out.

Signed-off-by: Marek Vasut <marek.vasut+rene...@gmail.com>
Cc: Nobuhiro Iwamatsu <iwama...@nigauri.org>
---
 drivers/serial/serial_sh.c | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/serial/serial_sh.c b/drivers/serial/serial_sh.c
index 13b179f03d..e27d256574 100644
--- a/drivers/serial/serial_sh.c
+++ b/drivers/serial/serial_sh.c
@@ -116,7 +116,10 @@ static int serial_getc_check(struct uart_port *port)
                handle_error(port);
        if (sci_in(port, SCLSR) & SCxSR_ORER(port))
                handle_error(port);
-       return status & (SCIF_DR | SCxSR_RDxF(port));
+       status &= (SCIF_DR | SCxSR_RDxF(port));
+       if (status)
+               return status;
+       return scif_rxfill(port);
 }
 
 static int sh_serial_getc_generic(struct uart_port *port)
-- 
2.28.0