Hi Zoolu,
> Thanks for your inputs.
>
> When i added Printf's at the area of Uncompressing Multi image and programmed
> new u-boot with debugs now the images boot. Does it mean that delay by
> printf's
> did the magic ?? which gave the time to uncompress the images ?
Well the printfs did something, although they don't have the power for
magic yet ;)
What printfs really change is the timing of sequences. If this makes a
difference between working and non-working setups, it may well be that
the hardware is also right on the fringe of the conditions where it
works flawlessly. So maybe the working hardware is just inside these
limits (because of tolerances of components) and the other hardware
isn't.
If I were you, the first thing I'd check is the power supply - maybe the
fast sequence is just enough to make it stumble. This is not
theoretical, I've seen this in designs changing "completely compatible"
parts against faster parts.
Best wishes
Detlev
--
(3) With sufficient thrust, pigs fly just fine. However, this is not
necessarily a good idea. It is hard to be sure where they are going to
land, and it could be dangerous sitting under them as they fly overhead.
-- The Twelve Networking Truths (RFC 1925)
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-40 Fax: (+49)-8142-66989-80 Email: d...@denx.de
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
