On Wed, Jun 10, 2020 at 5:37 PM Peter Robinson <pbrobin...@gmail.com> wrote:
>
> On Wed, Jun 10, 2020 at 10:11 PM Stuart Yoder <b08...@gmail.com> wrote:
> >
> > Hi Sylwester,
> >
> > I am trying to test v4 of your patch series for USB support on rpi4:
> > https://patchwork.ozlabs.org/project/uboot/list/?series=179078
> >
> > I am building u-boot 64-bit. Testing on a rpi4 B 1.2 board. But, USB is
> > not working for me and wanted to see if you had any ideas. Are there
> > other dependencies other than just applying your patch series?
> >
> > I've pasted the u-boot console output below.
> >
> > From what I can tell this board does not need the VL805 firmware
>
> 1.2 rev boards do need the firmware loading patch series, not sure
> about any other patches.
Are you sure? A colleague of mine said that it was in 1.4 that the flash
chip for the VL805 was removed. I can physically see that the flash
chip is on my board.
In any case, I did figure out one thing that was going on. I was using
the rpi4 DTB as it came shipped with my board. I found that on the
PCIe node there was a typo in the compatible string. I fixed that:
bus-range = <0x0 0x1>;
- compatible = "brcm,bcm7211-pcie",
"brcm,bcm7445-pcie", "brcm,pci-plat-dev";
+ compatible = "brcm,bcm2711-pcie",
"brcm,bcm7445-pcie", "brcm,pci-plat-dev";
max-link-speed = <0x2>;
...and USB now starts up and works.
Thanks,
Stuart
