[PATCH v3 3/5] imx8mp_evk: spl: use spl_early_init

[Fabio Estevam]

From: Peng Fan <peng....@nxp.com>

Use spl_early_init to replace spl_init, spl_init will be invoked
in board_init_r, we only need use spl_early_init to setup malloc
and scan early dt.

Signed-off-by: Peng Fan <peng....@nxp.com>
Signed-off-by: Fabio Estevam <feste...@gmail.com>
---
Changes since v2:
- None. Rebased against U-Boot master

 board/freescale/imx8mp_evk/spl.c | 12 ++++++------
 1 file changed, 6 insertions(+), 6 deletions(-)

diff --git a/board/freescale/imx8mp_evk/spl.c b/board/freescale/imx8mp_evk/spl.c
index 3b3112077a..6fc3df5aee 100644
--- a/board/freescale/imx8mp_evk/spl.c
+++ b/board/freescale/imx8mp_evk/spl.c
@@ -118,17 +118,17 @@ void board_init_f(ulong dummy)
 
        board_early_init_f();
 
-       preloader_console_init();
-
-       /* Clear the BSS. */
-       memset(__bss_start, 0, __bss_end - __bss_start);
-
-       ret = spl_init();
+       ret = spl_early_init();
        if (ret) {
                debug("spl_init() failed: %d\n", ret);
                hang();
        }
 
+       preloader_console_init();
+
+       /* Clear the BSS. */
+       memset(__bss_start, 0, __bss_end - __bss_start);
+
        enable_tzc380();
 
        setup_i2c(0, CONFIG_SYS_I2C_SPEED, 0x7f, &i2c_pad_info1);
-- 
2.17.1