Hi Marek,
On Thu, May 7, 2020 at 10:40 PM Marek Vasut <ma...@denx.de> wrote:
> Disable tiny printf in SPL, because that's really broken with
> dm_dump_all(), run dm_dump_all() just after power_init_board() in
> board/freescale/imx8m{p,q}_evk/spl.c and compare the results. There is
> likely gonna be a missing driver, my bet would still be on the clock.
That's a good suggestion. Yes, the clock drivers are missing for i.MX8MP.
Here is the comparison against a i.MX8MM EVK:
https://pastebin.com/raw/XVc6AAvr
I will activate them on SPL tomorrow.
Also, I noticed that i.MX8MM EVK has the following watchdog issues on master:
U-Boot SPL 2020.07-rc1-00387-g67887903af (May 07 2020 - 23:49:27 -0300)
Normal Boot
WDT: Started without servicing (60s timeout)
Trying to boot from MMC1
U-Boot 2020.07-rc1-00387-g67887903af (May 07 2020 - 23:49:27 -0300)
CPU: Freescale i.MX8MMQ rev1.0 at 1200 MHz
Reset cause: POR
Model: FSL i.MX8MM EVK board
DRAM: 2 GiB
WDT: Started without servicing (60s timeout)
MMC: FSL_SDHC: 1, FSL_SDHC: 2
Loading Environment from MMC... OK
In: serial
Out: serial
Err: serial
Net:
Warning: ethernet@30be0000 using MAC address from ROM
eth0: ethernet@30be0000
Hit any key to stop autoboot: 0
u-boot=>
It reboots after staying 60s in the U-Boot prompt.
Thanks
