Dne Po 23. srpna 2010 09:19:05 Miroslav Petricek napsal(a): > Dear members, > > > > I was playing with my MH mv2120 NAS device and it happened to me that I > stored some u-boot values and the device now hangs on boot. I am stupid I > know. > Why don't you ask your vendor ?
Cheers > > > Last thing I did was that I've set: > > > > setenv enaPost Yes > > setenv enaCpuStream Yes > > > > and saved them: > > > > saveenv > > > > Now my device hangs like this (taken from serial console) > > > > . > > \___/ |____/ \___/ \___/ \__| ** Forcing LOADER mode only ** > > ** MARVELL BOARD: RD-88F5182-NAS-P2 LE > > > > U-Boot 1.1.4 (Oct 12 2007 - 12:30:28) Marvell version: > 2.3.11_hp_1_3_1_bu...@hp > > > > U-Boot code: 00200000 -> 0026FFF0 BSS: -> 0027FDBC > > > > Soc: 88F5182 A2 (DDR2) > > CPU running @ 500Mhz > > SysClock = 166Mhz , TClock = 166Mhz > > > > DRAM CS[0] base 0x00000000 size 128MB > > DRAM Total size 128MB 32bit width > > Memory test pattern: 0x55555555, 0xAAAAAAAA, Pass > > [51...@fff80000] Flash: 512 kB > > Addresses 4M - 0M are saved for the U-Boot usage. > > Mem malloc Initialization (4M - 3M): Done > > > > CPU : ARM926 (Rev 0) > > Orion 1 streaming enabled > > > > And here it hangs. I wonder if there is any way hot to reset u-boot > settings. I mean some interrupt the POST by some magic key from serial > consoler or something. > > > > Do you think there is any possibility to debrick my device? > > > > Thanks, > > > > Mirek _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
