Hi Jagan, On Mon, Apr 20, 2020 at 9:37 PM Jagan Teki <ja...@amarulasolutions.com> wrote: > > Add U-Boot proper sector start offset for SiFive FU540. > This value is based on the partition layout supported > by SiFive FU540. > > u-boot.itb need to write on this specific offset so-that > the SPL will retrieve it from here and load. > > Signed-off-by: Jagan Teki <ja...@amarulasolutions.com> > --- > Changes for v2: > - none > > common/spl/Kconfig | 3 ++- > 1 file changed, 2 insertions(+), 1 deletion(-) > > diff --git a/common/spl/Kconfig b/common/spl/Kconfig > index 07eee56219..1ebb30344a 100644 > --- a/common/spl/Kconfig > +++ b/common/spl/Kconfig > @@ -308,7 +308,7 @@ config SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR > ARCH_MX6 || ARCH_MX7 || \ > ARCH_ROCKCHIP || ARCH_MVEBU || ARCH_SOCFPGA || \ > ARCH_AT91 || ARCH_ZYNQ || ARCH_KEYSTONE || OMAP34XX || \ > - OMAP44XX || OMAP54XX || AM33XX || AM43XX > + OMAP44XX || OMAP54XX || AM33XX || AM43XX || > TARGET_SIFIVE_FU540 > help > Use sector number for specifying U-Boot location on MMC/SD in > raw mode. > @@ -325,6 +325,7 @@ config SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR > default 0x300 if ARCH_ZYNQ || ARCH_KEYSTONE || OMAP34XX || OMAP44XX > || \ > OMAP54XX || AM33XX || AM43XX || ARCH_K3 > default 0x4000 if ARCH_ROCKCHIP > + default 0x822 if TARGET_SIFIVE_FU540 > help > Address on the MMC to load U-Boot from, when the MMC is being used > in raw mode. Units: MMC sectors (1 sector = 512 bytes). > --
It looks my comments in v1 patch is not addressed? Regards, Bin