What file transfer protocol do I use when sending an S-record file when I issue 
the loads command ?

I tried with both TerraTerm and Hyperterminal.

In Terraterm, when I use File | Send File ...,
In HyperTerminal, I use the menu Transfer | Send Text File ...

In both these cases, it reads the first line correctly, but by the time it 
wants to process the following line, it ends up reading garbage. It looks like 
the terminal programs kept sending bytes while U-boot was processing the first 
S-record line (which is an S0 record).

I also tried sending a file with the protocols Xmodem, Ymodem, Kermit.
Thy do not seem to work, or it is getting garbage (i.e. protocol specific 
headers, where it expects to see the actual S-record).

Our U-boot is based on 2008.10.


Any files attached to this e-mail will have been checked with virus detection 
software prior to transmission but you should carry out your own virus check 
before opening any attachment. Safetran Systems Corp does not accept liability 
for any damage or loss which may be caused by software viruses. The contents of 
this e-mail and any attachments are the property of Safetran Systems Corp and 
are intended for the confidential use by the named recipient only. They may be 
legally privileged and should not be communicated to, or relied upon, by any 
other person without written consent. If you are not the addressee, please 
notify us immediately at the following address:  Safetran Systems Corporation, 
2400 Nelson Miller Parkway, Louisville, Kentucky 40223. Safetran Systems Corp 
is a subsidiary of  Invensys Plc.  Registered office: Portland House, 
Bressenden Place, London, SW1E 5BF. UK Registered in England and Wales No. 
1641421.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to