On 23.04.20 13:18, Harald Seiler wrote: > Hello, > > On Wed, 2020-03-04 at 15:23 +0100, Harald Seiler wrote: >> Hello, >> >> continuing on the discussion around Claudius' patch for fixing reset in SPL >> [1] >> we have taken a closer look at the issue. To quickly summarize the >> situation: >> >> The original patch was to enable the generic ARM implementation of >> `do_reset` if CONFIG_SYSRESET is not enabled in SPL. This would break >> compilation for some boards which define their own `do_reset` in >> `board/*/spl.c`. >> >> To be more specific, the following 4 boards have this custom `do_reset`: >> >> - toradex/verdin-imx8mm >> - freescale/imx8mn_evk >> - freescale/imx8mm_evk >> - freescale/imx8mp_evk >> >> I hope we can all agree that `do_reset` is not at all meant to be implemented >> in board files. From looking at the related code for imx8m, it feels like >> this >> was just a workaround hack to archieve the same thing which Claudius has >> fixed. >> So this patch series reverts the addition of `do_reset` implementations in >> imx8m board files and instead switches to using the proper fix provided by >> Claudius. >> >> >> Additionally, the custom do_reset implementations were passing an address >> (WDOG1_BASE_ADDR) to `reset_cpu()` instead of 0. This is the only place in >> the >> entire U-Boot tree where this happens. Instead, all other implementations >> simply ignore the parameter and 0 is passed by callers. It looks a lot like >> this is a legacy left-over which makes me think that using it for a >> (hard-coded) >> watchdog address is not a good idea as it breaks convention with the rest of >> U-Boot. >> >> [1]: https://patchwork.ozlabs.org/patch/1201959 >> >> Claudius Heine (3): >> ARM: reset: use do_reset in SPL/TPL if SYSRESET was not enabled for >> them >> imx: imx8m*: Remove do_reset from board files >> imx: imx8m: Don't use the addr parameter of reset_cpu >> >> arch/arm/lib/Makefile | 2 +- >> arch/arm/mach-imx/imx8m/soc.c | 5 +---- >> board/freescale/imx8mm_evk/spl.c | 9 --------- >> board/freescale/imx8mn_evk/spl.c | 9 --------- >> board/freescale/imx8mp_evk/spl.c | 9 --------- >> board/toradex/verdin-imx8mm/spl.c | 9 --------- >> 6 files changed, 2 insertions(+), 41 deletions(-) >> > > Quick question, what is the situation with this series? Is there anything > which needs to be addressed?
Patches are fine IMHO - I will merge them soon. Stefano > > Without it, CONFIG_SPL_USB_SDP_SUPPORT is broken on the imx6q hardware > I am working with and I guess the same issue might exist on many other > boards as well (The USB stack needs a do_reset() implementation in SPL). > > Regards, > -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de =====================================================================