The FIT config node has reversed ATF and u-boot: ATF is set to
firmware but u-boot is set to loadable.
This script can work previously because spl fit driver wrongly
appends fdt to all loadable images. With the issue fixed, the u-boot
in loadable does not have fdt appended and fails to work.
So correct script by moving u-boot to firmware and ATF to loadable.
Signed-off-by: Ye Li <ye...@nxp.com>
---
arch/arm/mach-imx/mkimage_fit_atf.sh | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/arch/arm/mach-imx/mkimage_fit_atf.sh
b/arch/arm/mach-imx/mkimage_fit_atf.sh
index ad81d5e..dd1ca5a 100755
--- a/arch/arm/mach-imx/mkimage_fit_atf.sh
+++ b/arch/arm/mach-imx/mkimage_fit_atf.sh
@@ -116,8 +116,8 @@ if [ -f $BL32 ]; then
cat << __CONF_SECTION_EOF
config@$cnt {
description = "$(basename $dtname .dtb)";
- firmware = "atf@1";
- loadables = "uboot@1", "tee@1";
+ firmware = "uboot@1";
+ loadables = "atf@1", "tee@1";
fdt = "fdt@$cnt";
};
__CONF_SECTION_EOF
@@ -125,8 +125,8 @@ else
cat << __CONF_SECTION1_EOF
config@$cnt {
description = "$(basename $dtname .dtb)";
- firmware = "atf@1";
- loadables = "uboot@1";
+ firmware = "uboot@1";
+ loadables = "atf@1";
fdt = "fdt@$cnt";
};
__CONF_SECTION1_EOF
--
2.7.4
