Hi Marek, > From: Marek Vasut <ma...@denx.de> > Sent: mardi 31 mars 2020 18:59 > > On 3/31/20 5:22 PM, Patrick DELAUNAY wrote: > > Hi Marek, > > Hi, > > >> From: Marek Vasut <ma...@denx.de> > >> Sent: mardi 31 mars 2020 02:49 > >> > >> This series fixes the Avenger96 board. Since there are way too many > >> patches floating around on the ML and because I found various other > >> details that needed fixing, I decided to bundle the whole set of fixes > >> into this > series. > >> > >> This should go into current release, otherwise the board doesn't even boot. > >> This V2 is also roughly synchronized with the Linux V2 series fixing > >> very much the same issues. > > > > Do you expect all these paches in v2020.04 ? so in 5 days. > > Yes, the timing is bad, but this is fixing real bugs and is isolated to one > (two) > boards.
Ok, I will prepare pull request asap. [...] > > But for the rest of the serie, I prefer wait v2020.04 merge window and > > end of reviews (on U-Boot side and on Linux kernel side). > > > >> ARM: dts: stm32: Add QSPI NOR on AV96 > > This one you need to have working env storage. Yes I miss this point, but only for stm32mp15_dhcom_basic_defconfig NO issue for stm32mp15_basic_defconfig, the configuration for EV96 until now. I will take it. > >> ARM: dts: stm32: Use DT alias for the configuration EEPROM > >> ARM: dts: stm32: Add configuration EEPROM on AV96 OK, that fixes but only if stm32mp15_dhcom_basic_defconfig is used. > This one you need , otherwise ethernet MAC doesn't get correct MAC address. > > >> ARM: dts: stm32: Add alternate pinmux for ethernet RGMII OK > >> ARM: dts: stm32: Repair ethernet operation on AV96 No impact (as not supported by driver), I will take it. > This actually fixes ethernet. > > >> ARM: dts: stm32: Add missing ethernet PHY reset on AV96 > >> ARM: dts: stm32: Repair PMIC configuration on AV96 > > This fixes PMIC settings, so you do want this, otherwise the board is > unstable. I will take even if I have remark on buck1 min voltage and buck2 configuration (regulator-active-discharge) > >> ARM: dts: stm32: Adjust PLL4 settings on AV96 > > This one can probably wait, although it would make sense to put it in. Not yet review by AV96 upstreamer... I prefer wait. > >> ARM: dts: stm32: Split AV96 into DHCOR SoM and AV96 board > > This one can wait for next. > > [...] I am preparing the branch stm/master and the pull request. Thanks Patrick