Hi Stefan,
On Mon, Mar 23 2020, Stefan Roese wrote:
> On 27.01.20 21:01, Joel Johnson wrote:
>> While newer Linux kernels provide autoconfiguration of SFP, provide
>> an option for setting in U-Boot Kconfig for use prior to booting.
>>
>> Signed-off-by: Joel Johnson <mrj...@lixil.net>
>>
>> ---
>>
>> v2 changes:
>> - fixed help indentation
>> v3 changes:
>> - none
>> v4 changes:
>> - adjust static SerDes configuration at runtime instead of #ifdef
>> v5 changes:
>> - make independent of runtime detection
>>
>> ---
>> board/solidrun/clearfog/Kconfig | 7 +++++++
>> board/solidrun/clearfog/clearfog.c | 5 +++++
>> 2 files changed, 12 insertions(+)
>>
>> diff --git a/board/solidrun/clearfog/Kconfig
>> b/board/solidrun/clearfog/Kconfig
>> index 936d5918f8..c910e17093 100644
>> --- a/board/solidrun/clearfog/Kconfig
>> +++ b/board/solidrun/clearfog/Kconfig
>> @@ -15,4 +15,11 @@ config TARGET_CLEARFOG_BASE
>> detection via additional EEPROM hardware. This option enables
>> selecting
>> the Base variant for older hardware revisions.
>> +config CLEARFOG_SFP_25GB
>> + bool "Enable 2.5 Gbps mode for SFP"
>> + help
>> + Set the SFP module connection to support 2.5 Gbps transfer speed for
>> the
>> + SGMII connection (requires a supporting SFP). By default, transfer
>> speed
>> + of 1.25 Gbps is used, suitable for a more common 1 Gbps SFP module.
>> +
>> endmenu
>> diff --git a/board/solidrun/clearfog/clearfog.c
>> b/board/solidrun/clearfog/clearfog.c
>> index c873d00905..064ce4e520 100644
>> --- a/board/solidrun/clearfog/clearfog.c
>> +++ b/board/solidrun/clearfog/clearfog.c
>> @@ -63,6 +63,11 @@ int hws_board_topology_load(struct serdes_map
>> **serdes_map_array, u8 *count)
>> {
>> cf_read_tlv_data();
>> + /* Apply build configuration options before runtime configuration */
>> + if (IS_ENABLED(CONFIG_CLEARFOG_SFP_25GB))
>> + board_serdes_map[5].serdes_speed = SERDES_SPEED_3_125_GBPS;
>
> Just checking: Your option is for 2.5 gbps and you configure here to
> 3.125 gpbs. Is this intended?
This is intended. Serdes encoding is 8b/10b. So for 2.5Gbps you need
serdes rate of 3.125Gbps. For 1Gbps we already set 1.25Gpbs serdes rate
(SERDES_SPEED_1_25_GBPS) in board_serdes_map[].
baruch
--
http://baruch.siach.name/blog/ ~. .~ Tk Open Systems
=}------------------------------------------------ooO--U--Ooo------------{=
- bar...@tkos.co.il - tel: +972.52.368.4656, http://www.tkos.co.il -
