> On 2/19/20 7:55 PM, Marek Vasut wrote: > > From: Holger Brunck <holger.bru...@ch.abb.com> > > > > Add initial support for the ABB SECU board, which is an ArriaV-based > > SoCFPGA system with ethernet and booting from Denali NAND. > > > > Signed-off-by: Holger Brunck <holger.bru...@ch.abb.com> > > Cc: Ley Foon Tan <ley.foon....@intel.com> > > Cc: Simon Goldschmidt <simon.k.r.goldschm...@gmail.com> > > --- > > V2: Use CONFIG_SYS_I2C_EEPROM_ADDR in printf() in ivm.c > > Enable CONFIG_SYS_NAND_USE_FLASH_BBT > > --- > > arch/arm/dts/Makefile | 1 + > > arch/arm/dts/socfpga_arria5_secu1.dts | 130 +++++ > > arch/arm/mach-socfpga/Kconfig | 10 + > > board/keymile/Kconfig | 11 +- > > board/keymile/common/ivm.c | 19 +- > > board/keymile/secu1/Makefile | 7 + > > board/keymile/secu1/qts/iocsr_config.h | 694 > > ++++++++++++++++++++++++ board/keymile/secu1/qts/pinmux_config.h | > 218 ++++++++ > > board/keymile/secu1/qts/pll_config.h | 83 +++ > > board/keymile/secu1/qts/sdram_config.h | 327 +++++++++++ > > board/keymile/secu1/socfpga.c | 67 +++ > > configs/socfpga_secu1_defconfig | 84 +++ > > include/configs/socfpga_arria5_secu1.h | 131 +++++ > > So, this is missing MAINTAINERS file. I will just manually add it: > > $ cat board/keymile/secu1/MAINTAINERS > ABB SECU1 BOARD > M: Holger Brunck <holger.bru...@ch.abb.com> > S: Maintained > F: include/configs/socfpga_arria5_secu1.h > F: configs/socfpga_secu1_defconfig > > is that OK ?
yes, thank you. Best regards Holger
