On Thu, Jan 30, 2020 at 10:21 PM Masahiro Yamada <yamada.masah...@socionext.com> wrote: > > If the "source" command is not given the address, it uses > CONFIG_SYS_LOAD_ADDR, which is compile-time determined. > > Using the "loadaddr" environment variable is handier because it is > relocated according to the memory base when CONFIG_POSITION_INDEPENDENT > is enabled. > > Signed-off-by: Masahiro Yamada <yamada.masah...@socionext.com> > ---
Applied to u-boot-uniphier. > > include/configs/uniphier.h | 6 +++--- > 1 file changed, 3 insertions(+), 3 deletions(-) > > diff --git a/include/configs/uniphier.h b/include/configs/uniphier.h > index 29866668c491..b95fb9c93fa9 100644 > --- a/include/configs/uniphier.h > +++ b/include/configs/uniphier.h > @@ -169,17 +169,17 @@ > "ubi part UBI && " \ > "ubifsmount ubi0:boot && " \ > "ubifsload ${loadaddr} ${script} && " \ > - "source\0" \ > + "source $loadaddr\0" \ > "norscript=echo Running ${script} from tftp ... && " \ > "tftpboot ${script} &&" \ > - "source\0" \ > + "source $loadaddr\0" \ > "usbscript=usb start && " \ > "setenv devtype usb && " \ > "setenv devnum 0 && " \ > "run loadscript_fat\0" \ > "loadscript_fat=echo Running ${script} from ${devtype}${devnum} ... > && " \ > "load ${devtype} ${devnum}:1 ${loadaddr} ${script} && " \ > - "source\0" \ > + "source $loadaddr\0" \ > "sramupdate=setexpr tmp_addr $nor_base + 0x50000 &&" \ > "tftpboot $tmp_addr $second_image && " \ > "setexpr tmp_addr $nor_base + 0x70000 && " \ > -- > 2.17.1 > -- Best Regards Masahiro Yamada