On Wed, Dec 11, 2019 at 7:49 AM Fabio Estevam <feste...@gmail.com> wrote: > > Following the README instructions leads to a non-booting > U-Boot: > > U-Boot SPL 2020.01-rc3-00070-g9a0cbae22a (Nov 25 2019 - 13:08:24 -0300) > PMIC: PFUZE100 ID=0x10 > DDRINFO: start DRAM init > DDRINFO:ddrphy calibration done > DDRINFO: ddrmix config done > Normal Boot > Trying to boot from MMC2 > > (It hangs here) > > Use the "imx_4.19.35_1.0.0" ATF branch instead, which > fixes such problem and allow the boot to complete again.
Shouldn't we address the mix-match of the firmware-imx versions as well? I just increasing numbers over and over, and I was able to use firmware 8.5 which. The readme lists both 7.9 and 8.0. There is also a typo on the line that reads "./firmware-imx-8.0" which should have a .bin appended to it. It would nice to know what the differences are between the versions. adam > > Suggested-by: Adam Ford <aford...@gmail.com> > Signed-off-by: Fabio Estevam <feste...@gmail.com> > --- > board/freescale/imx8mq_evk/README | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > > diff --git a/board/freescale/imx8mq_evk/README > b/board/freescale/imx8mq_evk/README > index c1d400bcf9..4f671b069c 100644 > --- a/board/freescale/imx8mq_evk/README > +++ b/board/freescale/imx8mq_evk/README > @@ -11,7 +11,7 @@ Get and Build the ARM Trusted firmware > ====================================== > Note: srctree is U-Boot source directory > Get ATF from: https://source.codeaurora.org/external/imx/imx-atf > -branch: imx_4.14.62_1.0.0_beta > +branch: imx_4.19.35_1.0.0 > $ make PLAT=imx8mq bl31 > $ cp build/imx8mq/release/bl31.bin $(srctree) > > -- > 2.17.1 >
