po 21. 10. 2019 v 16:25 odesÃlatel Michal Simek <michal.si...@xilinx.com> napsal: > > All platforms which are using MANUAL_RELOC are jumping back to origin > location when repeatable command is called. The reason is that cmd_rep link > is not updated properly. Issue can be reproduced by rewriting origin > U-Boot location through (for example) file download by tftp command. > > Fixes: 80a48dd47e3b ("common: command: Rework the 'cmd is repeatable' logic") > Signed-off-by: Michal Simek <michal.si...@xilinx.com> > --- > > common/command.c | 5 +++++ > 1 file changed, 5 insertions(+) > > diff --git a/common/command.c b/common/command.c > index 4b887a267fb6..ceca99251076 100644 > --- a/common/command.c > +++ b/common/command.c > @@ -496,6 +496,11 @@ void fixup_cmdtable(cmd_tbl_t *cmdtp, int size) > for (i = 0; i < size; i++) { > ulong addr; > > + addr = (ulong)(cmdtp->cmd_rep) + gd->reloc_off; > + cmdtp->cmd_rep = > + (int (*)(struct cmd_tbl_s *, int, int, > + char * const [], int *))addr; > + > addr = (ulong)(cmdtp->cmd) + gd->reloc_off; > #ifdef DEBUG_COMMANDS > printf("Command \"%s\": 0x%08lx => 0x%08lx\n", > -- > 2.17.1 >
Queue for rc1 because this is big issue which should be fixed ASAP and only MB and m68k are affected by this patch. Thanks, Michal -- Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91 w: www.monstr.eu p: +42-0-721842854 Maintainer of Linux kernel - Xilinx Microblaze Maintainer of Linux kernel - Xilinx Zynq ARM and ZynqMP ARM64 SoCs U-Boot custodian - Xilinx Microblaze/Zynq/ZynqMP/Versal SoCs _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot