On Mon, Aug 26, 2019 at 11:28 PM Peng Fan <peng....@nxp.com> wrote: > <snip> > diff --git a/board/freescale/imx8mm_evk/README > b/board/freescale/imx8mm_evk/README > new file mode 100644 > index 0000000000..a885bc5c97 > --- /dev/null > +++ b/board/freescale/imx8mm_evk/README
Hi Peng, I'm working with an IMX8MM with U-Boot master + your v3 i.MX8MM-support series. I have a few comments and questions below. > @@ -0,0 +1,37 @@ > +U-Boot for the NXP i.MX8MM EVK board > + > +Quick Start > +=========== > +- Build the ARM Trusted firmware binary > +- Get ddr fimware > +- Build U-Boot > +- Boot > + > +Get and Build the ARM Trusted firmware > +====================================== > +Note: srctree is U-Boot source directory > +Get ATF from: https://source.codeaurora.org/external/imx/imx-atf > +branch: imx_4.19.35_1.0.0 > +$ make PLAT=imx8mm bl31 > +$ cp build/imx8mm/release/bl31.bin $(srctree) > + > +Get the ddr and hdmi firmware There is no HDMI on i.MX8MM so remove 'hdmi' above > +============================= > +$ wget https://www.nxp.com/lgfiles/NMG/MAD/YOCTO/firmware-imx-8.0.bin > +$ chmod +x firmware-imx-8.0.bin > +$ ./firmware-imx-8.0 > +$ cp firmware-imx-7.9/firmware/ddr/synopsys/lpddr4*.bin $(srctree) typo: cp firmware-imx-8.0 > + > +Build U-Boot > +============ > +$ export CROSS_COMPILE=aarch64-poky-linux- > +$ make imx8mm_evk_defconfig > +$ export ATF_LOAD_ADDR=0x920000 > +$ make flash.bin Build fails due to default_serial_console undefined. Did you need to enable DM_SERIAL? After enabling DM_SERIAL build fails during image creation: MKIMAGE u-boot.itb ./tools/imx8m_image.sh spl/u-boot-spl.cfgout 1 26061+0 records in 26061+0 records out 104244 bytes (104 kB, 102 KiB) copied, 0.0458568 s, 2.3 MB/s MKIMAGE flash.bin Not support no fit arch/arm/mach-imx/Makefile:151: recipe for target 'flash.bin' failed If I hack using_fit=1 into tools/imx8mimage.c I can build flash.bin but it does not boot. Am I missing some additional necessary patches to tools? Best Regards, Tim > + > +Burn the flash.bin to MicroSD card offset 33KB > +$sudo dd if=flash.bin of=/dev/sd[x] bs=1024 seek=33 > + > +Boot > +==== > +Set Boot switch to SD boot _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot