> Subject: Re: [PATCH v2 00/26] i.MX8MM support > > On 19.08.19 11:42, Peng Fan wrote: > > V2: > > Fixed comments from Lukasz and Frieder > > This set has 26 patches, while the previous version had 22. You should > document all changes here, so one can easily figure out which patches were > added/removed/merged/split.
The following 4 are new added. I'll address your comments and send out v3. imx8m: imx-regs: drop unused register definitions imx8m: restrict reset_cpu imx: mmc_env: update runtime SD/MMC boot env device imx8m: soc: probe clock device in arch_cpu_init_dm Thanks, Peng. > > > > > V1: > > https://eur01.safelinks.protection.outlook.com/?url=https%3A%2F%2Fpatc > > > hwork.ozlabs.org%2Fcover%2F1144326%2F&data=02%7C01%7Cpeng.fa > n%40nx > > > p.com%7C1809390d35d9451070f208d72a378af1%7C686ea1d3bc2b4c6fa92c > d99c5c3 > > > 01635%7C0%7C0%7C637024290371709641&sdata=kZkJN9G%2F4vZu5c > RqzHxMWS0 > > 6DENq9y2yUSZVjTfUjyY%3D&reserved=0 > > This is a splitted and updated patch from > > https://eur01.safelinks.protection.outlook.com/?url=https%3A%2F%2Fpatc > > > hwork.ozlabs.org%2Fcover%2F1128799%2F&data=02%7C01%7Cpeng.fa > n%40nxp.com%7C1809390d35d9451070f208d72a378af1%7C686ea1d3bc2b4 > c6fa92cd99c5c301635%7C0%7C0%7C637024290371709641&sdata=oh > OMPQavonAd22u4tFvQTNQzOq%2FWr5YsZlZ3DfEGWRM%3D&reserved > =0 which is to support both i.MX8MM and i.MX8MN. > > > > There is a README added, following that to test if you would like to. > > > > Peng Fan (25): > > tools: imx8m_image: align spl bin image size > > ddr: imx8m: fix ddr firmware location when enable SPL OF > > imx8m: add image cfg for i.MX8MM lpddr4 > > imx: add IMX8MQ kconfig entry > > imx: add IMX8MM kconfig entry > > imx: imx8mm: add clock bindings header > > imx: add i.MX8MM cpu type > > imx: spl: add spl_board_boot_device for i.MX8MM > > imx8m: imx-regs: drop unused register definitions > > imx8m: update imx-regs for i.MX8MM > > imx: add get_cpu_rev support for i.MX8MM > > imx8m: add pin header for i.MX8MM > > imx: add i.MX8MM PE property > > imx8m: Fix MMU table issue for OPTEE memory > > imx8m: set BYPASS ID SWAP to avoid AXI bus errors > > imx8m: soc: enable SCTR clock before timer init > > imx8m: restrict reset_cpu > > imx8m: rename clock to clock_imx8mq > > imx8m: restructure clock.h > > imx8m: add clk support for i.MX8MM > > imx: mmc_env: update runtime SD/MMC boot env device > > imx8m: soc: probe clock device in arch_cpu_init_dm > > arm: dts: import i.MX8MM dtsi > > arm: dts: add i.MX8MM pin func > > imx: Add i.MX8MM EVK board support. > > > > Ye Li (1): > > imx8m: Configure trustzone region 0 for non-secure access > > > > arch/arm/dts/Makefile | 3 +- > > arch/arm/dts/imx8mm-evk-u-boot.dtsi | 92 + > > arch/arm/dts/imx8mm-evk.dts | 235 +++ > > arch/arm/dts/imx8mm-pinfunc.h | 629 > +++++++ > > arch/arm/dts/imx8mm.dtsi | 733 > ++++++++ > > arch/arm/include/asm/arch-imx/cpu.h | 6 + > > arch/arm/include/asm/arch-imx8m/clock.h | 491 +---- > > arch/arm/include/asm/arch-imx8m/clock_imx8mm.h | 387 > ++++ > > arch/arm/include/asm/arch-imx8m/clock_imx8mq.h | 424 > +++++ > > arch/arm/include/asm/arch-imx8m/imx-regs.h | 291 +-- > > arch/arm/include/asm/arch-imx8m/imx8mm_pins.h | 691 > +++++++ > > arch/arm/include/asm/mach-imx/iomux-v3.h | 4 + > > arch/arm/include/asm/mach-imx/sys_proto.h | 8 + > > arch/arm/mach-imx/cpu.c | 12 + > > arch/arm/mach-imx/imx8m/Kconfig | 17 +- > > arch/arm/mach-imx/imx8m/Makefile | 4 +- > > arch/arm/mach-imx/imx8m/clock_imx8mm.c | 306 > +++ > > .../arm/mach-imx/imx8m/{clock.c => clock_imx8mq.c} | 5 +- > > arch/arm/mach-imx/imx8m/clock_slice.c | 63 + > > arch/arm/mach-imx/imx8m/imximage-8mm-lpddr4.cfg | 16 + > > arch/arm/mach-imx/imx8m/soc.c | 129 +- > > arch/arm/mach-imx/mmc_env.c | 3 + > > arch/arm/mach-imx/spl.c | 8 + > > board/freescale/imx8mm_evk/Kconfig | 12 + > > board/freescale/imx8mm_evk/MAINTAINERS | 6 + > > board/freescale/imx8mm_evk/Makefile | 12 + > > board/freescale/imx8mm_evk/imx8mm_evk.c | 45 + > > board/freescale/imx8mm_evk/lpddr4_timing.c | 1980 > ++++++++++++++++++++ > > board/freescale/imx8mm_evk/spl.c | 129 ++ > > configs/imx8mm_evk_defconfig | 74 + > > drivers/ddr/imx/imx8m/helper.c | 12 +- > > include/configs/imx8mm_evk.h | 153 ++ > > include/dt-bindings/clock/imx8mm-clock.h | 253 +++ > > tools/imx8m_image.sh | 5 +- > > 34 files changed, 6535 insertions(+), 703 deletions(-) > > create mode 100644 arch/arm/dts/imx8mm-evk-u-boot.dtsi > > create mode 100644 arch/arm/dts/imx8mm-evk.dts > > create mode 100644 arch/arm/dts/imx8mm-pinfunc.h > > create mode 100644 arch/arm/dts/imx8mm.dtsi > > create mode 100644 > arch/arm/include/asm/arch-imx8m/clock_imx8mm.h > > create mode 100644 > arch/arm/include/asm/arch-imx8m/clock_imx8mq.h > > create mode 100644 > arch/arm/include/asm/arch-imx8m/imx8mm_pins.h > > create mode 100644 arch/arm/mach-imx/imx8m/clock_imx8mm.c > > rename arch/arm/mach-imx/imx8m/{clock.c => clock_imx8mq.c} (99%) > > create mode 100644 > arch/arm/mach-imx/imx8m/imximage-8mm-lpddr4.cfg > > create mode 100644 board/freescale/imx8mm_evk/Kconfig > > create mode 100644 board/freescale/imx8mm_evk/MAINTAINERS > > create mode 100644 board/freescale/imx8mm_evk/Makefile > > create mode 100644 board/freescale/imx8mm_evk/imx8mm_evk.c > > create mode 100644 board/freescale/imx8mm_evk/lpddr4_timing.c > > create mode 100644 board/freescale/imx8mm_evk/spl.c > > create mode 100644 configs/imx8mm_evk_defconfig > > create mode 100644 include/configs/imx8mm_evk.h > > create mode 100644 include/dt-bindings/clock/imx8mm-clock.h > > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
