The main purpose of this patch series is to allow the AQR driver to run on
a larger number of boards without having to use a custom aquantia FW on each
of them. Configuration points that are exclusively controlled by PHY firmware
are not configured based on phydev->interface as well as new DT node properties.
The patch set introduces a couple of new interface types (XFI and USXGMII),
introduces a couple of binding documents and updates the ENETC eth driver to use
the new interface types.
Changes in v2:
- Flip USX AN bit both ways as needed, in v1 it was only set for USXGMII
but not reset for XFI
- Use CONFIG_DM_ETH instead of CONFIG_OF_CONTROL around the codeu using
phydev->node
- Use variable name interface instead of if_type for consistency with
the rest of the code.
Alex Marginean (11):
include: phy: define XFI and USXGMII interface types
include: phy: add data field for private driver data
drivers: net: aquantia: use XFI, USXGMII interface types
drivers: net: aquantia: add PHY generation information
drivers: net: aquantia: set up SI protocol based on interface type
drivers: net: aquantia: set MDI reversal based on DT property
drivers: net: aquantia: set SMBus addr based on DT property
drivers: net: aquantia: use SI and LI status in loop waiting for link
up
doc: bindings: add bindings document for PHY nodes
doc: bindings: Aquantia PHY node binding
drivers: net: fsl_enetc: use XFI, USXGMII interface type macros
doc/device-tree-bindings/net/aquantia-phy.txt | 25 ++
doc/device-tree-bindings/net/phy.txt | 24 ++
drivers/net/fsl_enetc.c | 2 +
drivers/net/phy/aquantia.c | 229 ++++++++++++++++--
include/phy.h | 3 +
include/phy_interface.h | 4 +
6 files changed, 268 insertions(+), 19 deletions(-)
create mode 100644 doc/device-tree-bindings/net/aquantia-phy.txt
create mode 100644 doc/device-tree-bindings/net/phy.txt
--
2.17.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
