On Fri, Jul 12, 2019 at 2:07 PM Simon Goldschmidt <simon.k.r.goldschm...@gmail.com> wrote: > > The designware eth driver registers an mdio bus during probe, but if no > PHY is found, this bus is never removed although probe failes and the > driver is shown as not probed in the dm tree. > > This later leads to errors when e.g. the mii or mdio commands try to > use available mdio buses because the mdio bus is still registered but > all corresponding data structures are invalid because probe failed. > > Fix this by unregistering the mdio bus on probe failure (just as it is > unregistered in the .remove callback, too). > > Signed-off-by: Simon Goldschmidt <simon.k.r.goldschm...@gmail.com>
Acked-by: Joe Hershberger <joe.hershber...@ni.com> _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
