Marek Vasut <ma...@denx.de> Thursday 20th June 2019 22:56:
> Enable DM support for regulators and fixed regulator driver and
> convert USB Vbus control over to the regulators defined in DT.
>
> Signed-off-by: Marek Vasut <ma...@denx.de>
> Cc: Ludwig Zenz <lz...@dh-electronics.com>
> Cc: Stefano Babic <sba...@denx.de>
> ---
> board/dhelectronics/dh_imx6/dh_imx6.c | 17 -----------------
> configs/dh_imx6_defconfig | 2 ++
> 2 files changed, 2 insertions(+), 17 deletions(-)
>
> diff --git a/board/dhelectronics/dh_imx6/dh_imx6.c
> b/board/dhelectronics/dh_imx6/dh_imx6.c
> index 50e3cb50a3..e5ff91248a 100644
> --- a/board/dhelectronics/dh_imx6/dh_imx6.c
> +++ b/board/dhelectronics/dh_imx6/dh_imx6.c
> @@ -196,7 +196,6 @@ int board_eth_init(bd_t *bis)
> #ifdef CONFIG_USB_EHCI_MX6
> static void setup_usb(void)
> {
> - gpio_request(IMX_GPIO_NR(3, 31), "USB-VBUS");
> /*
> * Set daisy chain for otg_pin_id on MX6Q.
> * For MX6DL, this bit is reserved.
> @@ -211,22 +210,6 @@ int board_usb_phy_mode(int port)
> else
> return USB_INIT_DEVICE;
> }
> -
> -int board_ehci_power(int port, int on)
> -{
> - switch (port) {
> - case 0:
> - break;
> - case 1:
> - gpio_direction_output(IMX_GPIO_NR(3, 31), !!on);
> - break;
> - default:
> - printf("MXC USB port %d not yet supported\n", port);
> - return -EINVAL;
> - }
> -
> - return 0;
> -}
> #endif
>
> static int setup_dhcom_mac_from_fuse(void)
> diff --git a/configs/dh_imx6_defconfig b/configs/dh_imx6_defconfig
> index 70f0277040..3f615b4634 100644
> --- a/configs/dh_imx6_defconfig
> +++ b/configs/dh_imx6_defconfig
> @@ -64,6 +64,8 @@ CONFIG_FEC_MXC=y
> CONFIG_MII=y
> CONFIG_PINCTRL=y
> CONFIG_PINCTRL_IMX6=y
> +CONFIG_DM_REGULATOR=y
> +CONFIG_DM_REGULATOR_FIXED=y
> CONFIG_DM_SCSI=y
> CONFIG_SPI=y
> CONFIG_DM_SPI=y
> --
> 2.20.1
>
>
Tested-by: Ludwig Zenz <lz...@dh-electronics.com>
Thanks,
Regards
Ludwig Zenz
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
