Am 15.05.2019 um 20:12 schrieb Adam Ford:
I am trying to add DM support in SPL along with device tree support
similar to how it's being done for the omap3_logic boards.
Unfortunately, I think something is going wrong in the initialization
with CONFIG_DM enabled for SPL because I get no text data, and it
doesn't appear to boot.
I tried enabling DM in SPL and using the older platdata method without
success. I have disabled DM_SERIAL in SPL and tried enabling the
serial debug stuff, and I get nothing. I don't have a debugger, so
it's a bit more difficult to troubleshoot.
The main difference between the am35 and omap3 is the memory
controller, and I've tried to model the am35 after the omap3 boards I
also maintain. I was hoping someone might have any suggestions on how
to track down the issue. As of right now, I have OF_CONTROL working
in U-Boot and with DM disabled in SPL, everything is good.
I don't know that mach, but reading the files, you're calling
'spl_early_init()' from your 'board_init_f()'. The problem I had there
was that I did not have enough heap - and notice you need pre-reloc heap
enabled.
spl_early_init() parses the dts and binds the drivers, and even the
default CONFIG_SPL_SYS_MALLOC_F_LEN of 1 KiB wasn't enough for me. Oh,
and of course you need CONFIG_SYS_MALLOC_F enabled when calling
spl_early_ini() from board_init_f in SPL.
Regards,
Simon
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
