> This patch enable convert DM MMC for imx7d-pico board and variant.
> Before the DM conversion only usdhc3 was enabled and therefore it appeared
> as MMC 0 to u-boot. After enabling MMC DM though usdhc3 defaults to MMC 2,
> which left unattended would drive changes to existing pico-pi bootscripts and
> environment variables that rely on mmc 0.
> Setup the alias of mmc0 and usdhc3 so that existing pico-imx7d boot code will
> work unmodified.
> When converting to DM_MMC it is necessary that SPL initializes eMMC
> by itself, so move the original eMMC initialization from U-Boot
> proper to SPL.
> Signed-off-by: Joris Offouga <offougajo...@gmail.com>
> Signed-off-by: Fabio Estevam <feste...@gmail.com>

Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot

Reply via email to