On 4/9/19 9:02 PM, Simon Goldschmidt wrote: > By enabling debug prints in malloc_simple, we can see that SPL for socfpga > gen5 does by far not need the 8 KiB malloc pool currently allocated for > SPL in pre-reloc phase. > > On socfpga_socrates, 1304 bytes are currently used (and this increases by > ~200 bytes only for the sdram/reset fixes in socfpga-next). > > To prevent wasting precious SRAM space, let's reduce the initial heap used > for SPL to 2 KiB. This is still some hundred bytes more than currently > used. Also, the gen5 SPL enables stack and heap in DDR memory pretty > early. Only the initial uclass/dm parsing, serial console and DDR > initialization is done in the initial heap, so these 2 KiB should be > enough for all boards. > > Signed-off-by: Simon Goldschmidt <simon.k.r.goldschm...@gmail.com> > --- > > Changes in v4: None > Changes in v3: > - adapt to socfpga-next > > Changes in v2: > - added patch to reduce gen5 SPL initial malloc pool to 2 KiB > > arch/arm/mach-socfpga/Kconfig | 3 +++ > 1 file changed, 3 insertions(+) > > diff --git a/arch/arm/mach-socfpga/Kconfig b/arch/arm/mach-socfpga/Kconfig > index 3c6c63067d..8f7b79f586 100644 > --- a/arch/arm/mach-socfpga/Kconfig > +++ b/arch/arm/mach-socfpga/Kconfig > @@ -6,6 +6,9 @@ config NR_DRAM_BANKS > config SPL_STACK_R_ADDR > default 0x00800000 if TARGET_SOCFPGA_GEN5 > > +config SPL_SYS_MALLOC_F_LEN > + default 0x800 if TARGET_SOCFPGA_GEN5 > + > config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_TYPE > default 0xa2 > >
Acked-by: Marek Vasut <ma...@denx.de> -- Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot