Dear All
We are using ubispl to load u-boot from a UBI volume on a TI am335x
based board using the am335x_spl_bch driver. In the current ubispl
code (common/spl/spl_ubi.c, line 45), the number of PEBs is hardcoded
to CONFIG_SPL_UBI_MAX_PEBS.
In order to support multiple hardware variants with different flash
sizes with one SPL, it would be nice to set this value on the
fly. However if I understand correctly, the SPL nand driver does
not autodetect such properties.
Is there a practical way to determine this value in the SPL context?
Or should it be provided by board init code? What would be the
preferred way to handle this?
Thanks in advance!
MarkusMarkus Klotzbuecher Embedded System Architect -- Kistler Instrumente AG Eulachstrasse 22, 8408 Winterthur, Switzerland Direct +41 52 224 17 54, Main Office +41 52 224 11 11 markus.klotzbuec...@kistler.com, www.kistler.com _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
