From: Marcel Ziswiler <marcel.ziswi...@toradex.com>
Migrate USB to using driver model.
Signed-off-by: Marcel Ziswiler <marcel.ziswi...@toradex.com>
---
board/toradex/colibri_imx6/colibri_imx6.c | 23 +----------------------
configs/colibri_imx6_defconfig | 1 +
2 files changed, 2 insertions(+), 22 deletions(-)
diff --git a/board/toradex/colibri_imx6/colibri_imx6.c
b/board/toradex/colibri_imx6/colibri_imx6.c
index ef4dd0c87c..adb5a3df4c 100644
--- a/board/toradex/colibri_imx6/colibri_imx6.c
+++ b/board/toradex/colibri_imx6/colibri_imx6.c
@@ -289,28 +289,7 @@ int board_ehci_hcd_init(int port)
imx_iomux_v3_setup_multiple_pads(usb_pads, ARRAY_SIZE(usb_pads));
return 0;
}
-
-int board_ehci_power(int port, int on)
-{
- switch (port) {
- case 0:
- /* control OTG power */
- /* No special PE for USBC, always on when ID pin signals
- host mode */
- break;
- case 1:
- /* Control MXM USBH */
- /* Set MXM USBH power enable, '0' means on */
- gpio_request(GPIO_USBH_EN, "USBH_EN");
- gpio_direction_output(GPIO_USBH_EN, !on);
- mdelay(100);
- break;
- default:
- break;
- }
- return 0;
-}
-#endif /* CONFIG_USB_EHCI_MX6 */
+#endif
#if defined(CONFIG_FSL_ESDHC) && defined(CONFIG_SPL_BUILD)
/* use the following sequence: eMMC, MMC */
diff --git a/configs/colibri_imx6_defconfig b/configs/colibri_imx6_defconfig
index 2ab7db44a8..df5a7be39f 100644
--- a/configs/colibri_imx6_defconfig
+++ b/configs/colibri_imx6_defconfig
@@ -68,6 +68,7 @@ CONFIG_DM_REGULATOR_PFUZE100=y
CONFIG_DM_REGULATOR_FIXED=y
CONFIG_IMX_THERMAL=y
CONFIG_USB=y
+CONFIG_DM_USB=y
CONFIG_USB_KEYBOARD=y
CONFIG_USB_GADGET=y
CONFIG_USB_GADGET_MANUFACTURER="Toradex"
--
2.20.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
