All platforms are converted to DM_I2C that's why there is no reason to
keep this code here.
Signed-off-by: Michal Simek <michal.si...@xilinx.com>
---
Changes in v2:
- Add dependency
board/xilinx/common/board.c | 19 -------------------
configs/zynq_zybo_defconfig | 1 -
drivers/misc/Kconfig | 1 +
3 files changed, 1 insertion(+), 20 deletions(-)
diff --git a/board/xilinx/common/board.c b/board/xilinx/common/board.c
index b14f530c72c5..7e6340bad6d4 100644
--- a/board/xilinx/common/board.c
+++ b/board/xilinx/common/board.c
@@ -8,24 +8,6 @@
#include <dm/uclass.h>
#include <i2c.h>
-#if !defined(CONFIG_DM_I2C)
-int zynq_board_read_rom_ethaddr(unsigned char *ethaddr)
-{
-#if defined(CONFIG_ZYNQ_GEM_EEPROM_ADDR) && \
- defined(CONFIG_ZYNQ_GEM_I2C_MAC_OFFSET) && \
- defined(CONFIG_ZYNQ_EEPROM_BUS)
- i2c_set_bus_num(CONFIG_ZYNQ_EEPROM_BUS);
-
- if (eeprom_read(CONFIG_ZYNQ_GEM_EEPROM_ADDR,
- CONFIG_ZYNQ_GEM_I2C_MAC_OFFSET,
- ethaddr, 6))
- printf("I2C EEPROM MAC address read failed\n");
-#endif
-
- return 0;
-}
-
-#else
int zynq_board_read_rom_ethaddr(unsigned char *ethaddr)
{
int ret = -EINVAL;
@@ -54,4 +36,3 @@ int zynq_board_read_rom_ethaddr(unsigned char *ethaddr)
return ret;
}
-#endif
diff --git a/configs/zynq_zybo_defconfig b/configs/zynq_zybo_defconfig
index 64b635bfd68b..4ba329cd92bd 100644
--- a/configs/zynq_zybo_defconfig
+++ b/configs/zynq_zybo_defconfig
@@ -39,7 +39,6 @@ CONFIG_DFU_RAM=y
CONFIG_FPGA_XILINX=y
CONFIG_FPGA_ZYNQPL=y
CONFIG_DM_GPIO=y
-CONFIG_ZYNQ_GEM_I2C_MAC_OFFSET=0xFA
CONFIG_MMC_SDHCI=y
CONFIG_MMC_SDHCI_ZYNQ=y
CONFIG_SPI_FLASH=y
diff --git a/drivers/misc/Kconfig b/drivers/misc/Kconfig
index 704c8dd1955f..d6e677fba847 100644
--- a/drivers/misc/Kconfig
+++ b/drivers/misc/Kconfig
@@ -245,6 +245,7 @@ config SPL_I2C_EEPROM
config ZYNQ_GEM_I2C_MAC_OFFSET
hex "Set the I2C MAC offset"
default 0x0
+ depends on DM_I2C
help
Set the MAC offset for i2C.
--
1.9.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
