Andreas, On 4/21/2010 1:27 AM, andreas.g...@baslerweb.com wrote: > From: Andreas Gaeer<andreas.g...@baslerweb.com> > > Without this change the MAC address only gets properly set when the > ethaddr is already set in u-boot environment. > > Now the board setup should do the following: > 1. Put a valid ethaddr into environment (eg. by I2C EEPROM) > 2. Call dv_set_mac_address() to set the address in TI EMAC driver > > Please read the documentation. This is not how it's done. The programming of MAC addresses is currently in flux. I suggest you wait a few days and then see if changes are needed.
regards, Ben _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
