Rely on the phy-reset-gpios which is set in imx6qdl-sabresd dtsi
and get rid of the enet reset gpio handling from the board file.
Signed-off-by: Abel Vesa <abel.v...@nxp.com>
---
board/freescale/mx6sabresd/mx6sabresd.c | 7 -------
1 file changed, 7 deletions(-)
diff --git a/board/freescale/mx6sabresd/mx6sabresd.c
b/board/freescale/mx6sabresd/mx6sabresd.c
index 71b9bfe..c9f2076 100644
--- a/board/freescale/mx6sabresd/mx6sabresd.c
+++ b/board/freescale/mx6sabresd/mx6sabresd.c
@@ -94,13 +94,6 @@ static iomux_v3_cfg_t const enet_pads[] = {
static void setup_iomux_enet(void)
{
SETUP_IOMUX_PADS(enet_pads);
-
- /* Reset AR8031 PHY */
- gpio_request(IMX_GPIO_NR(1, 25), "ENET PHY Reset");
- gpio_direction_output(IMX_GPIO_NR(1, 25) , 0);
- mdelay(10);
- gpio_set_value(IMX_GPIO_NR(1, 25), 1);
- udelay(100);
}
static iomux_v3_cfg_t const usdhc2_pads[] = {
--
2.7.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
