> -----Original Message----- > From: York Sun > Sent: Tuesday, November 20, 2018 2:13 AM > To: Ashish Kumar <ashish.ku...@nxp.com>; u-boot@lists.denx.de > Cc: Yogesh Narayan Gaur <yogeshnarayan.g...@nxp.com>; Rajat Srivastava > <rajat.srivast...@nxp.com> > Subject: Re: [PATCH v3] fsl-lsch3: soc: Enable AHB read support for Flexspi > controller > > On 11/12/18 11:26 PM, Ashish Kumar wrote: > > Enable AHB support for Flexspi controller interface meaning memory can > > be accessed via md command using absolute addresses > > > > Signed-off-by: Yogesh Gaur <yogeshnarayan.g...@nxp.com> > > Signed-off-by: Rajat Srivastava <rajat.srivast...@nxp.com> > > Signed-off-by: Ashish Kumar <ashish.ku...@nxp.com> > > --- > > v3: > > Depends upon http://patchwork.ozlabs.org/patch/975009/ Hi York,
Sorry that was typo, it was meant to be http://patchwork.ozlabs.org/patch/974301/. But unfortunately after lot of delay in review on NXP-FlexSPI driver, it has been asked to re-write to a new frame-work. I think I should defer this http://patchwork.ozlabs.org/patch/975008/ and http://patchwork.ozlabs.org/patch/996846/ for the time being until 974301 is re-written. What do you suggest? Regards Ashish > > Your v3 patch depends on its v2 version. This doesn't make sense. > > York _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
