> -----Original Message----- > From: u-boot-boun...@lists.denx.de > [mailto:u-boot-boun...@lists.denx.de] On Behalf Of Heiko Schocher > Sent: Tuesday, April 06, 2010 12:49 PM > To: Ben Warren > Cc: u-boot@lists.denx.de > Subject: Re: [U-Boot] [RFC] Program net device MAC addresses > after initializing > > Hello Ben, > > Ben Warren wrote: > > Add a new function to the eth_device struct for programming > a network > > controller's hardware address. > > > > After all network devices have been initialized and the > proper MAC address for > > each has been determined, make a device driver call to > program the address > > into the device. Only device instances with valid unicast > addresses will be > > programmed. > > > > This is a significant departure from existing U-boot > behavior, but costs very > > little in startup time and addresses a very common > complaint among developers. > > > > Signed-off-by: Ben Warren <biggerbadder...@gmail.com> > > Acked-by: Heiko Schocher <h...@denx.de>
Acked-by: Prafulla Wadaskar <prafu...@marvell.com> Regards.. Prafulla . . > > bye > Heiko > -- > DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel > HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany > _______________________________________________ > U-Boot mailing list > U-Boot@lists.denx.de > http://lists.denx.de/mailman/listinfo/u-boot > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot