When the bus switches to 1.8V mode of operation, it is necessary to
verify that the card correctly initiated and completed the voltage
switch. This is done by reading out the state of DATA0 line.
This patch implement support for reading out the state of the DATA0
line, so the MMC core code can correctly switch to 1.8V mode.
Signed-off-by: Marek Vasut <marek.vasut+rene...@gmail.com>
Cc: Masahiro Yamada <yamada.masah...@socionext.com>
---
V2: No change
V3: No change
---
drivers/mmc/renesas-sdhi.c | 27 ++++++++++++++++++++++++++-
1 file changed, 26 insertions(+), 1 deletion(-)
diff --git a/drivers/mmc/renesas-sdhi.c b/drivers/mmc/renesas-sdhi.c
index 884b4a5cc8..73f6bf1562 100644
--- a/drivers/mmc/renesas-sdhi.c
+++ b/drivers/mmc/renesas-sdhi.c
@@ -308,13 +308,38 @@ static int renesas_sdhi_set_ios(struct udevice *dev)
return ret;
}
+#if CONFIG_IS_ENABLED(MMC_UHS_SUPPORT)
+static int renesas_sdhi_wait_dat0(struct udevice *dev, int state, int timeout)
+{
+ int ret = -ETIMEDOUT;
+ bool dat0_high;
+ bool target_dat0_high = !!state;
+ struct tmio_sd_priv *priv = dev_get_priv(dev);
+
+ timeout = DIV_ROUND_UP(timeout, 10); /* check every 10 us. */
+ while (timeout--) {
+ dat0_high = !!(tmio_sd_readl(priv, TMIO_SD_INFO2) &
TMIO_SD_INFO2_DAT0);
+ if (dat0_high == target_dat0_high) {
+ ret = 0;
+ break;
+ }
+ udelay(10);
+ }
+
+ return ret;
+}
+#endif
+
static const struct dm_mmc_ops renesas_sdhi_ops = {
.send_cmd = tmio_sd_send_cmd,
.set_ios = renesas_sdhi_set_ios,
.get_cd = tmio_sd_get_cd,
-#if CONFIG_IS_ENABLED(MMC_HS200_SUPPORT)
+#if CONFIG_IS_ENABLED(MMC_UHS_SUPPORT) || CONFIG_IS_ENABLED(MMC_HS200_SUPPORT)
.execute_tuning = renesas_sdhi_execute_tuning,
#endif
+#if CONFIG_IS_ENABLED(MMC_UHS_SUPPORT)
+ .wait_dat0 = renesas_sdhi_wait_dat0,
+#endif
};
#define RENESAS_GEN2_QUIRKS TMIO_SD_CAP_RCAR_GEN2
--
2.18.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
